-
Subroutine name PROC NEAR (or FAR) … ret Subroutine name ENDP (1) NEAR attribute (near call within a segment): the calling program and the subroutine are in the same code segment and can only be c...[Details]
-
When testing VF, brightness, and wavelength, the current must be set to 20mA. When testing VR, IR must be set to 10uA. When testing IR, VR must be set to 5V. When testing and using LEDs, the same...[Details]
-
T/C2: 8-bit timer/counter that generates pulse width modulated signals with no output jitter and adjustable phase.
FOC2 Forced Output Compare: Only valid when WGM indicates non-PWM mode. Howeve...[Details]
-
1 Introduction
In recent years, environmental and energy issues have become hot issues of concern to countries around the world. With the worsening of environmental pollution and energy crisis...[Details]
-
1 Introduction
Bluetooth technology is based on chips and provides short-range wireless frequency hopping communication. It has low power requirements and can be embedded in any digital ...[Details]
-
Mouser Electronics and Samtec hold connector solutions seminar to promote innovation in connection design
August 24, 2022 – Mouser Electronics, an electronic component distributor fo...[Details]
-
Global semiconductor equipment spending has entered an upward cycle. The application of new technologies and new products such as 5G, Internet of Things, big data, artificial intelligence, and automo...[Details]
-
The development of DDR is towards higher data transmission frequency and larger memory capacity. DDR2 achieves higher data transmission frequency, and develops from DDR's 2-bit pretetch to 4-bit pret...[Details]
-
"Open the door." "Close Sesame." "I want to go to the fifth floor." These childlike sentences are actually voice commands to control the elevator. In the current epidemic situation, elevators are ve...[Details]
-
November 19, 2021 - Mouser Electronics, an electronic component distributor focused on introducing new products to drive industry innovation, announced that it will launch the " New Infrastructure" s...[Details]
-
Traditional multi-machine
communication systems
usually require four lines to complete:
1. Power line; 2. Ground line; 3. Send signal line; 4. Receive signal line. However,...[Details]
-
ADC The computer world is 0 and 1. The microcontroller can determine the state of a button by reading 0 and 1, and can also output 0 and 1 to control an LED. Even PWM, which does not seem to be 0 and...[Details]
-
PIC 8-bit microcontrollers have only one interrupt entry (16-bit and 32-bit microcontrollers have multiple interrupts), so there can only be one interrupt subroutine in the program. If two or more int...[Details]
-
introduce
Digital signal processing (DSP) is a specialized method of processing signals and data with the purpose of enhancing and modifying these signals. Digital signal processing is also u...[Details]
-
Three-phase bridge fully controlled rectifier circuit
The most widely used, common cathode group - 3 thyristors connected together with cathode (VT1, VT3, VT5) common anode group - 3 thyristors co...[Details]
Talking
京公网安备 11010802033920号
EEWORLD