Resistance to sulphur-bearing gas (AS version only): ASTM-B-809
Voltage proof
Volts
Note: A 0.01 Ohm addition to be added to the performance of all resistors <10 Ohms.
ΔR%
ΔR%
ΔR%
ΔR%
ΔR%
1
1
1
0.25
0.25
0.25
500
ΔR%
ΔR%
Maximum
1
0.1
Zero at 155°C
0.1
0.2
0.25
0.05
0.05
0.05
Typical
0.25
0.02
Pulse Performance Data
Pulse Performance Data
Lightning Surge
Lightning surge resistors are tested in accordance with IEC 60 115-1 using both 1.2/50µs and 10/700µs pulse shapes. 10 pulses are applied. The limit of
acceptance is a shift in resistance of less than 1% from the initial value.
2512
2010
1206
0805
0603
Lightning Surge
Lightning surge resistors are tested in
accordance with IEC 60 115-1 using
both 1.2/50µs and 10/700µs pulse shapes.
10 pulses are applied. The limit of
acceptance is a shift in resistance of less
than 1% from the initial value.
2512
2010
1206
0805
0603
General Note
TT Electronics reserves the right to make changes in product specification without notice or liability.
All information is subject to TT Electronics’ own data and is considered accurate at time of going to print.
The single impulse graph is the result of 50 impulses of rectangular shape applied at one minute intervals. The limit of acceptance was a shift in
resistance of less than 1% from the initial value.
2512
2010
1206
0805
0603
Continuous Load Due to Repetitive Pulses
The continuous load graph was obtained by applying repetitive rectangular pulses where the pulse period was adjusted so that the average
power dissipated in the resistor was equal to its rated power at 70°C. Again the limit of acceptance was a shift in resistance of less than 1% from the
initial value
2512
2010
1206
0805
0603
General Note
TT Electronics reserves the right to make changes in product specification without notice or liability.
All information is subject to TT Electronics’ own data and is considered accurate at time of going to print.
[i=s]This post was last edited by L_954863658 on 2020-3-16 13:52[/i]There are two zigbee modules, one for burning the coordinator program and the other for burning the node program. The node is always...
[i=s]This post was last edited by flashtt on 2020-10-11 09:39[/i]I changed my direction after I started working, and I will no longer use the boards I bought at school. I am selling them to forum frie...
I want to design an analog amplifier circuit to achieve the same amplification factor for two input signals with different frequencies. If I use an AGC circuit to implement such an analog amplifier ci...
LTpowerPlanner System-Level Design Tool Quick Start Guide
Modern electronic systems are becoming increasingly complex. There may be a large number of power rails and power solutions on a system board,...
DescriptionThis TI reference design provides a low-component-count, low-cost solution for a 4 to 20mA loop-powered resistance temperature detector (RTD) temperature transmitter. The design uses the on...
1. The power supply is 5V constant voltage, the maximum output current is 0.35A, and the resistance of the DC motor is 62.6 ohms. In the circuit below, if pin 1A inputs a low level, 1Y will output a h...
RF/Wirelessly
京公网安备 11010802033920号
EEWORLD
