ECOsine® high power passive harmonic filter modules
Compact cabinet filter for quick installation and
easy commissioning
Cost-effective enclosed passive harmonic filter
Optimized for motor drives with DC-link
chokes
Helps to comply with international power
quality standards
Supports an efficient utilization of electrical
system capacity
Filters for diode rectifiers
Approvals
Typical application
Schaffner ECOsine filter cabinets can be applied to
virtually any kind of power electronics with front-end
six-pulse rectifiers, where harmonic current distortion
needs to be reduced to defined limits. The compact
filter cabinets can be easily commissioned and
quickly installed into extisting designs without
requiring an in-depth system analysis or highly
trained specialists.
Typical applications include higher power AC and DC
motor drives with either six diode used e.g. in HVAC,
water/wastewater, oil & gas, or mission critical factory
automation equipment. In addition, ECOsine filters
can help to reduce thermal and electrical overload
caused by harmonic currents in installations involving
UPS, high power rectifiers and other non-linear three-
phase power supplies.
Technical specifications
Nominal operating voltage
Operating frequency
Total harmonic current distortion THID*
Total demand distortion TDD
Voltage tolerance range
Nominal motor drive input power rating
Efficiency
High potential test voltage
Protection category
Cooling
Overload capability
Ambient temperature range
3x 380 to 500 VAC
50 Hz +/-1 Hz
~5% @ rated power with Ldc
<15% @ de-rated power without Ldc
According to IEEE-519
3x 342 to 550 VAC
200 to 400 kW
≥99% @ nominal line voltage and power
P –> E 2500 VAC (2 sec)
IP 23 for -E2 type filters
IP 54 for -E5 type filters
Forced air
1.6x rated current for 1 minute, once per hour
-25°C to +40°C fully operational
-25°C to +85°C transport and storage
+40°C to +60°C de-rated operation**
UL 94V-2 or better
UL 508c, EN 61558-2-20, CE (LVD 2006/95/EC)
100 kA
TN, TT, IT
Flammability according to
Design corresponding to
SCCR***
Earthing System
*** System requirements: THVD <2%, line voltage unbalance <1%
** *Note:
performance specifications in this brochure refer to six-pulse diode rectifiers
*** Iderated = Inominal * √(85°C-Tamb)/45°C
*** External UL-rated fuses required
2
PQ/Harmonics
Schaffner Group
Datasheets
2016
Performance characteristics
THID – Total harmonic current
distortion
ECOsine high power passive harmonic filter
performance is optimized for rectifiers/motor drives
with a dc-link choke. In such applications, a THID of
roughly 5% can be expected. The use of a dc-link
choke is highly recommended. In a system without
L
dc
, the filter module has to be derated to max. 70% of
its nominal power rating. In such applications, a THID
of 10…15% can be expected.
Displacement power factor
At full load, ECOsine filters yield unity power factor.
At lower load levels, the capacitive current into the
power capacitors of the trap circuit cause a leading
displacement power factor. This is the case with all
types of passive filters with large capacitors. However,
compared to traditional filters the useful range of
Schaffner ECOsine is much extended (cos phi >0.9
from 35 to 100% of rated load).
ECOsine filters allow for trap disconnect at light load
to avoid low DPF situations if required. This feature
can be provided by the installer using a capacitor
contactor of suitable size for the trap circuit.
DC-link voltage
ECOsine harmonic filters have a very low impact on
the dc-link voltage of the motor drive. The voltage
variation as function of the load is represented in the
performance diagram beside. Tolerances are kept
narrow in order to ensure that motor drives do not
suffer from noise tripping because of under- or over-
voltage conditions.
3
PQ/Harmonics
Schaffner Group
Datasheets
2016
Filter selection table (-E2)
Filter
Rated load power*
@ 400 VAC/50 Hz
[kW]
FN 3410-380-99-E2
FN 3410-470-99-E2
FN 3410-580-99-E2
FN 3410-650-99-E2
FN 3410-710-99-E2
200
250
315
355
400
Rated load power*
@ 500 VAC/50 Hz
[kW]
250
315
355
400
450
Typ. power loss
@ rated load
[W]
1040
1370
1540
1550
1680
Weight
choke module
[kg]
120
135
160
215
250
[kg]
241
265
292
373
410
Weight total
* Power rating for motor drives with dc-link chokes. If no Ldc is available, load power of the filter has to be de-rated to 70% of the specified value above
In this case, the THID will be between 10-15%
Filter selection table (-E5)
Filter
Rated load power*
@ 400 VAC/50 Hz
[kW]
FN 3410-380-99-E5
FN 3410-470-99-E5
FN 3410-580-99-E5
FN 3410-650-99-E5
FN 3410-710-99-E5
200
250
315
355
400
Rated load power*
@ 500 VAC/50 Hz
[kW]
250
315
355
400
450
Typ. power loss
@ rated load
[W]
1040
1370
1540
1550
1680
Weight
choke module
[kg]
120
135
160
215
250
[kg]
244
268
295
376
413
Weight total
* Power rating for motor drives with dc-link chokes. If no Ldc is available, load power of the filter has to be de-rated to 70% of the specified value above
In this case, the THID will be between 10-15%
Application
ECOsine filters are best installed directly at the input of 6-pulse rectifiers. It is possible to connect several non-linear loads (e.g. motor drives) in parallel. In this case the
rating of the filter must match the sum of the power ratings of loads connected to it.
[i=s]This post was last edited by jinglixixi on 2020-11-1 00:14[/i]1. Use GPIO port to simulate I2C interface
An LED flashing program is provided in the example. Through it, we can master the method o...
Recently, Pmos is used as a ms-level switch circuit. IRF5305s is selected, and the circuit schematic is shown in Figure 1. The signal is the MCU signal 3.3v, and the power supply is 12v. The MCU contr...
I need help with the component library, because I am used to building the circuit in multisim... After building it, I found that I couldn't find the components and couldn't make the board...
As shown in the figure below: ZJ8V voltage is 8V, VSTAND voltage should be 5V, but the actual voltage is 2.96V. When R113 is removed and R112 is short-circuited, the voltage is 2.5V, which is normal....
[i=s]This post was last edited by tiankai001 on 2018-11-29 12:20[/i] [size=4] [color=#333333][font="]Radio, a practical item that is deeply rooted in daily life, a former luxury item, and a witness of...
Qorvo (NASDAQ: QRVO), a leading provider of innovative RF solutions that connect the world, today introduced the first wideband front-end module (FEM) covering the 5.1 GHz to 7.1 GHz frequency band fo...
Shanghai, China, April 22, 2024 -
amsram, a leading global supplier of optical solutions, announced today that amsram CEO and Chairman of the Board Otto Kamp visited BYD's Shenzhen headquarters...[Details]
Abstract: The charge-pump voltage converter is known mostly in its doubler and inverter configuration. This article focuses on the voltage-splitter charge-pump configuration, which divides the input v...[Details]
To achieve the goal of autonomous driving, ADAS applications are being developed in full swing. The demand for microcontrollers, sensor chips, and graphics processors built into various smart cars ...[Details]
Wound-rotor asynchronous motors and squirrel-cage asynchronous motors are both asynchronous motors. The difference between them lies in the rotor. The rotor winding of a wound-rotor asynchronous mo...[Details]
China Energy Storage Network News:
On January 14, 2018, Mr. Chen from Hangzhou and his family drove to Liangjiadun, a popular village in Haining City, Zhejiang Province. While they were havin...[Details]
The latest report from market research firm Counterpoint shows that global smartwatch shipments in the third quarter of 2020 increased by 6% compared with the same period last year. Image source: C...[Details]
0 Introduction
Power line communications (PLC) is a communication method that uses power lines as a communication medium. Power lines have never been an ideal communication medium, but wit...[Details]
introduction
As competitors in the field of solid-state image sensors, CCD and CMOS image sensors each have their own advantages and disadvantages in performance.
Compared with CCD image ...[Details]
1 Introduction
With the development of modern science and technology, inverter power supplies are widely used in all walks of life, which puts forward higher requirements for their per...[Details]
According to a research and statistical report released by iResearch Consulting, by the end of 2019, the market size of China's public charging service industry may exceed 15 billion yu...[Details]
1. Experimental task
: Use the table to make the port P1 change a single light: move left 2 times, move right 2 times, and flash 2 times (delay time 0.2 seconds).
2. Circuit diagram
Fig...[Details]
AT89C51 is a low voltage, high performance CMOS 8-bit microprocessor with 4K bytes of flash programmable and erasable read-only memory (FPEROM), commonly known as a single-chip microcomputer. The dev...[Details]
C. Speech Recognition
Simple speech recognition can be achieved using the high-speed AD detection function of the AVR microcontroller. After the sound signal is received by the electret condenser m...[Details]
The "14th Five-Year Plan"
for the Development of
Robot
Industry proposes that by 2025, China will have achieved a number of breakthroughs in core robot technologies and high-end products, wi...[Details]
The switching power supply circuit of a color TV set includes an anti-interference circuit, a rectifier filter circuit, a degaussing circuit, a start-up circuit, a switching oscillator circuit, a fee...[Details]
Domestic Chip Exchange
京公网安备 11010802033920号
EEWORLD
