1.5SMCJ SERIES
SURFACE MOUNT TRANSIENT VOLTAGE SUPPRESSOR PEAK PULSE POWER 1500 Watts
STAND-OFF VOLTAGE
5 to 220 Volts
Recongnized File # E210467
FEATURES
0.245(6.22)
0.280(7.11)
0.260(6.60)
0.012(0.305)
0.006(0.152)
0.103(2.62)
0.079(2.00)
0.008(0.203)
0.002(0.051)
0.128(3.25)
• For surface mounted applications in order to optimize board space.
• Glass passivated junction
• Low inductance
• Plastic package has Underwriters Laboratory Flammability
Classification 94V-O
• High temperature soldering : 260°C /10 seconds at terminals
• Lead free in comply with EU RoHS 2011/65/EU directives
• Green molding compound as per IEC61249 Std. . (Halogen Free)
MECHANICAL DATA
• Case: JEDEC DO-214AB,Molded plastic over passivated junction.
• Terminals: Solder plated,solderable per MIL-STD-750, Method 2026
• Polarity: Color band denotes cathode end
• Standard Packaging: 16mm tape (EIA-481)
• Weight: 0.007 ounce, 0.021 gram
0.050(1.27)
0.030(0.76)
0.320(8.13)
0.305(7.75)
DEVICES FOR BIPOLAR APPLICATIONS
For Bidirectional use C or CA Suffix for types 1.5SMCJ5.0 thru types 1.5SMCJ220.
Electrical characteristics apply in both directions.
MAXIMUM RATINGS AND CHARACTERISTICS
Rating at 25°Cambient temperature unless otherwise specified. Resistive or inductive load, 60Hz.
For Capacitive load derate current by 20%.
Rating
Peak Power Dissipation at T
A
=25
O
C, T
P
=1ms (Notes 1)
Peak Pulse Current on 10/1000μs waveform (Notes 1)
Typical Thermal Resistance Junction to Air (Notes 2)
Peak Forward Surge Current, 8.3ms Single Half Sine-Wave
Superimposed on Rated Load (JECED Method) (Notes 3)
Operating Junction and Storage Temperature Range
Symbol
P
PP
I
PPM
R
θJA
I
FSM
T
J
,T
STG
Value
1500
See table
50
200
-55 to +150
Units
Watts
Amps
O
0.108(2.75)
0.220(5.59)
C/W
Amps
O
C
NOTES:
1.Non-repetitive current pulse, per Fig. 3 and derated above T
A
=25°Cper
Fig. 2.
2.Mounted on 2.0mm
2
( .013mm thick) land areas.
3.Measured on 8.3ms , single half sine-wave or equivalent square wave , duty cycle= 4 pulses per minutes maximum.
4.A transient suppressor is selected according to the working peak reverse voltage (V
RWM
), which should be equal to or greater than the DC
or continuous peak operating voltage level.
November 5,2012-REV.03
PAGE . 1
View All
Test/Measurement
京公网安备 11010802033920号
EEWORLD
