Production of 6n3 Pushing 6p1 Single-ended Tube Amplifier
Source: InternetPublisher:吃掉星星 Keywords: Power amplifier circuit Updated: 2024/11/06
6n3 push 6p1 single-ended production
Two 6p1 power tubes are used for stereo class A output, with an output power of dual 2-3W. Since the 6p1 tube works in pure class A, the sound quality is sweet, and the actual distortion-free volume is equivalent to that of a 15W transistor amplifier. Equipped with a high-sensitivity speaker, it is mainly used to appreciate human voices and light music, and its timbre is as pure as that of high-end audio!
Adopt 6n3 single-stage amplifier without large loop feedback circuit
Actual production:
This time, a 45w radio amplifier is used, with full-wave rectification, 150uf+340ohm+150uf filtering, and the output uses a small single-ended amplifier from Sugon Laoyi! The overall quality is very high, and audiophiles who are interested can make it, the sound will not disappoint you!
The power transformer is removed from the red light machine (double 230, 6.3, 6.3) with three outputs. I use the output transformer from Shuguang Laoyi Niu! You can also use a small power transformer (5-10w) to modify it. The details are as follows: The output impedance of the 6p1 class (6p14/6p15, etc.) small power tube is about 5k ohms, and the load speaker impedance is 4/8 ohms. The primary coil ratio of the output transformer is
From this calculation, when Rs=4oum, n=31, which is consistent with the 220/6.3v transformer.
When Rs=8oum, n=22.3, which is consistent with the 220/9v transformer. This voltage ratio can be used as a substitute for a 10w power transformer.
Since the output transformer has direct current passing through it, the iron core is prone to magnetic saturation. Therefore, the iron core of the power transformer converted into an output transformer must be disassembled, and the original staggered insert method is changed to stack the E and I sheets respectively and then insert them oppositely. A 0.2mm thick film is placed at the junction of the two parts of the iron core for magnetic isolation. The inserts must be tight, otherwise it will affect the sound quality.
The test was also satisfactory:
- 6P3P parallel 20W power amplifier experiment
- Sugon New Tube 2A3C Single-ended Tube Amplifier
- Make a pocket amplifier with 8550 and 8050
- Preamplifier made of 6P15 tube
- DIY a stylish Bluetooth speaker
- Electronic bird repeller for crops
- Improved Marantz 7-tube preamplifier circuit
- 2W×2 power amplifier circuit using LM1877
- 8W audio power amplifier circuit composed of LM2002/LM2002A
- Horseshoe gallbladder preamplifier circuit
- DV (CL) type power amplifier circuit
- AP500 and its application circuit (d)
- Simple 100W power amplifier circuit
- 30W power amplifier circuit
- Field effect transistor OCL power amplifier circuit
- Two-stage difference amplifier OCL amplifier
- 50WOTL power amplifier circuit
- Pure DC FET power amplifier circuit 03
- Feiyue 12D3 black and white TV audio OTL power amplifier circuit
- Bridge power amplifier circuit for DC motor speed regulation