Optoelectronic relay circuit using operational amplifier
Source: InternetPublisher:清宁时光 Keywords: Optoelectronics operational amplifiers relay circuits BSP Updated: 2020/03/12
It uses an operational amplifier and a phototransistor VTi as the detection element. In the figure, Ra
is the feedback resistor, and its size determines the amplification factor of the operational amplifier; RP. It is the zero adjustment potentiometer; Cl and R. Complement the
taste with phase. If LM324 operational amplifier is used, Cl and R4 can be deleted.
When no light shines on the phototransistor VTi, pin 6 of operational amplifier
A outputs a high level, and the transistor VTz
guides the relay KA. When there is light, pin 6 of A outputs a low level, VT2 cuts off, and KA freed.
- Controlling LEDs with Multithreading via Dual-Core Programming on Raspberry Pi using MicroPython
- Homemade Bluetooth controlled car using HC-05 Bluetooth module to communicate with mobile phone
- A small improvement to the temperature and water level indicator alarm
- Motor automatic cycle control circuit
- Motor control circuit for starting and running without phase loss
- Design and production of wireless multi-location control switch circuit
- Amplitude and phase detection leakage protection device designed and manufactured using PIC16C711A
- Guanghua brand anti-theft doorbell electronic lock circuit
- Homemade short circuit alarm device
- Simple disconnection burglar alarm
- electromagnetic field sensor
- Ultrasonic blind pathfinder circuit
- Mixer built with analog multipliers
- Diode square rate detection circuit
- Amplitude modulation circuit composed of MC1496
- Common emitter-common base wideband amplifier circuit composed of F733 integrated amplifier
- Differential Amplifier Circuit
- common emitter amplifier circuit
- Color display circuit
- Guest arrival signal recognition circuit
京公网安备 11010802033920号