Home >
Control Circuits >Motor Control > The process and phase relationship of the driving signal from t2 to t3 (240° to 360°)
The process and phase relationship of the driving signal from t2 to t3 (240° to 360°)
Source: InternetPublisher:吃掉星星 Keywords: transistor coil Updated: 2021/03/14
The process and phase relationship of the driving signal from t2 to t3 (240° to 360°)
At time t2~t3 (240.-3600): As shown in the figure, when the transistors w+ and U- are turned on, other transistors are turned off. The signal flow
is that the power supply current passes through the positive terminal - w+ transistor - W coil -_U coil - U- transistor - R806 - negative terminal or to ground.
Latest Control Circuits Circuits
- Design and selection of electric control valve system drive
- Use your smartphone to turn on/off the power in your home
- A small improvement on the ordinary refrigerator motor starting circuit
- Design and principle analysis of practical electric curtain remote control device
- IGBT modules block overcurrent by controlling the gate
- Do-it-yourself trial production of phase failure protection device
- Electric vehicle battery charging protection circuit
- Motorcycle anti-theft device circuit design
- Precious home appliance anti-theft alarm
- Bicycle anti-theft alarm
Popular Circuits
- Agricultural spraying and insecticide control circuit
- fire smoke control circuit
- Electronic rhythm control circuit
- Mobile phone camera flash control circuit
- Traffic traffic light control circuit
- Three-phase stepper motor control circuit
- Haier KFR-25GW air conditioner control circuit schematic diagram
- Electric heater temperature detection control circuit
- DC motor forward and reverse control circuit
- Wide input range non-synchronous voltage mode control circuit
京公网安备 11010802033920号