Flashing light making circuit diagram
Source: InternetPublisher:super_star Keywords: lamp circuit diagram contacts relay Updated: 2020/09/05
The circuit working principle of the device is shown in the figure. Plug in the power plug CT. Since the normally closed contact j1 of the relay J is closed, the lamp H lights up. And since the normally open contact j2 is open, the ④ pin of LSE outputs a low level. At this time, the transistor VT conducts Pass. After VT is turned on, relay J is excited and closed, contact j1 is opened, H goes out, and contact j2 is closed at the same time, so the output of LSE pin 4 is high level at this time, transistor VT is cut off, relay J is released, and contact j1 It closes again, H lights up, and contact j2 opens again... This cycle works over and over again, causing the light H to flash.
- BA6104 five-digit LED level meter driver integrated circuit basic application circuit
- Isolated two-wire current loop circuit (XTR101, ISO100)
- Constant current LED lamp driver circuit with soft start and anti-shock
- Parallel DC regulated power supply circuit diagram
- Principles and precautions of active discharge circuit
- How to use SBR to improve power conversion efficiency
- Miniature polarity reversal power supply using MAX1721
- Charging control circuit made by solar energy
- Power supply circuit that can reduce LM317 ripple
- Practical constant current charger-----Constant current charger
- STR5412 power circuit
- Power circuit of STR5412
- Portable device charging power circuit design
- Three-way DC-DC converter circuit
- 500A-6V single-phase thyristor voltage regulating electroplating power supply circuit
- Simple dual-channel variable DC power supply circuit
- Timing switch AC power circuit
- Household emergency power circuit
- Wide input 350mA LED driver circuit based on NCL30000
- High quality power supply circuit schematic diagram