Automobile window automatic control circuit diagram
Source: InternetPublisher:张小哥 Keywords: Automatic control circuit control circuit diagram Updated: 2021/05/16
Two half-bridge intelligent power driver chips BTS 7960B are combined into a full-bridge driver to drive the DC motor to rotate to raise or lower the window. BTS7960B is a high-current half-bridge integrated chip used in motor driving. It has a P-channel high-side MOSFET, an N-channel low-side MOSFET and a driver 1C. P-channel high-side switch eliminates the need for a charge pump. requirements, thereby reducing electromagnetic interference (EMI). The integrated driver IC has logic level input, current diagnosis, slope adjustment, dead time generation and over-temperature, over-voltage, under-voltage, over-current and short-circuit protection functions. The typical on-state resistance value of BTS7960B is 16mfl, and the driving current can reach 4.3A, so even in the cold winter, the safe start of the car window can still be ensured. Adjusting the size of the external resistor connected to the SR pin can adjust the MOS tube turn-on and turn-off time, and has the function of preventing electromagnetic interference. The 1S pin is the current detection output pin. The INH pin is the enable pin, and the IN pin is used to determine which MOSFET is turned on. When lN-1 and INH-1. The high-side MOSFET is turned on and outputs a high level. When IN=O and INH-1, the low-side MOSFET is turned on and outputs a low level. It is controlled by the 16-bit microcontroller XC164CS. The switching action of BTS7960B is used to regularly monitor the system status. Receive appropriate fault feedback signals and exchange fault information and key control information with the central body controller through the vehicle network (CAN bus), thereby displaying the fault content on the user interface in a timely manner and controlling the electric windows in real time. In order to avoid current spikes when the window motor starts. The soft-start function is realized by controlling the pulse width modulation (PWM) signal with a frequency of 20kHz on the lower arm switch tube.
- A very convenient small power supply circuit to share
- Using Lead-acid Battery as Power Source for Walkman
- Driving circuit of switching power supply field effect tube
- Energy-saving motorcycle rectifier regulator
- LED Driver ZD1680
- Parallel DC regulated power supply circuit diagram
- Miniature polarity reversal power supply using MAX1721
- Electric bicycle battery charger circuit
- Design of electric vehicle charger
- Detailed explanation of mobile phone charger circuit diagram
- Closed-loop control circuit diagram of single-ended forward converter
- CV/CC control circuit diagram of half-bridge resonant controller based on CM6900
- Empty process control circuit diagram
- Backup power control circuit diagram
- Use electric contact pressure gauge to make water level control circuit diagram
- DC motor forward and reverse control circuit diagram
- Dual-circuit insurance starting and automatic switching control circuit diagram
- Another forward and reverse control circuit diagram to prevent phase short circuit
- Forward rotation control circuit diagram with self-locking
- TTL server control circuit diagram