Simple voltage regulator tube tester circuit
Source: InternetPublisher:桂花蒸 Updated: 2011/11/04
The simple voltage regulator tube tester can directly measure the voltage stabilization value of the voltage regulator tube and is very convenient to make. The electrical principle is shown in the figure below. The IC can be F007, CA3140, μA741 and other amplifiers. R3 should be a 22K straight-slide potentiometer. R3 is required to accurately calibrate the voltage value according to the positive power supply voltage and mark it on the casing.
In addition, due to the limitation of IC operating voltage, the test is limited to voltage regulator tubes with a voltage regulator value below 30V.
In addition, due to the limitation of IC operating voltage, the test is limited to voltage regulator tubes with a voltage regulator value below 30V. Latest Detection Circuits Circuits
- Homemade Metal Detector
- Four logic probe circuit diagrams
- 5 tone detector circuit diagram
- Electric vehicle luminous voltmeter with undervoltage alarm
- Application of TDA1514
- PHGS-4 computer multi-channel industrial acidity meter circuit 01
- Simple password electric lock
- Geiger counter circuit diagram
- Differential amplifier circuit
- Sample and hold circuit diagram
Popular Circuits
- LED lighting display detection circuit with overload protection
- Towel machine fault detection circuit
- Bus door status detection circuit
- Combustible gas concentration detection circuit
- Detect the major point waveforms of the circuit
- Cable automatic detection circuit
- Cordless telephone ring current detection circuit
- Human body detection circuit for infrared sensor
- Portable CO detection circuit using dual-electrode sensor
- Revolution detection circuit
京公网安备 11010802033920号