NRF52832 keeps resetting after adding ble service

y909334873

NRF52832 keeps resetting after adding ble service [Copy link]

I just started to use nrf52832 recently, and tested it according to the ble_app_uart routine in the nRF5_SDK_15.0.0_a53641a version provided by the official nrf52832. The relevant burning test in the official board is normal. When burning to my own board, it keeps resetting, but if I remove the ble service-related functions in the routine and only keep the basic module functions of gpio, adc, and uart, it works normally. I don't know if any big guys have encountered similar problems. Are there any settings required? The protocol stack has also been burned. It may also be a hardware problem. Those who know about it are welcome to give me advice. Thank you

申小林

Eliminate 0 replies, come and give you a thumbs up! ! ! ! !

w2006

I also encountered this problem, did you solve it?

y909334873

w2006 posted on 2018-12-19 17:33 I also encountered this problem, have you solved it?

The external crystal oscillator has a problem, you can change the internal clock to test and see if it can solve it

星空188

Hello, I have the same problem. Can you add me at 1242634601?

星空188

qq1242634601, looking forward to the host adding me~

领越电子

SYD8811 vs nR*52832 (Pin to pin compatible, no need to change the board)