Why is this pin header green?

chenbingjy

Why is this pin header green? [Copy link]

 

I use AD10 to draw, why is this pin green? I reset the rule check, it is not green, but as soon as I move it, it is green again. I want to make it not green once and for all, do I have to change the rule? If so, which rule should I change? Thank you!

曹伟1993

Who knows which rule to change? It's just a picture. It could be the spacing or something else. Can you change the minimum spacing and see if it works?

littleshrimp

Copy the pin header to another project and check the design rules.

machinnneee

It seems to be a rule error. Check the rules to see which error it is. Is it that the opening and welding layer violate the rules? This is a minor problem.

servo-leetro

You right-clicked in the wrong location and there is a violation. Here you can see exactly where the error occurred.

gmchen

Judging from the picture, the most likely reason is that the spacing is too small. Try to reduce the spacing in the inspection rules or reduce the diameter of these pads.

wsdymg

The highlighted green ones are errors. Are you using the standard package library? If you are using the standard library, you can check to see if the rules are set incorrectly.

柠檬酸钠

Directly check the drc rules, then click the message on the left to see the details.

huaiqiao

Do you have pictures? Can you please include both pictures and text when posting? Otherwise, I can only guess based on the meaning of your text.

chenbingjy

huaiqiao posted on 2017-12-25 10:15 Do you have pictures? When you post, can you try to include both pictures and text? . . . . . . . . . . . Otherwise, I can only guess based on the meaning of your text

Do you have pictures?

huaiqiao

Click the green area with your mouse, and there will be information displayed in the upper right corner of the interface. Just change the specifications according to the error information.

chenbingjy

huaiqiao posted on 2017-12-25 18:24 Click the mouse on the green area, and there will be information displayed in the upper right corner of the interface. Just change the specifications according to the error information

It's over. I finished drawing the board and asked my leader to check it. As a result, the leader did not let me draw it anymore, saying that my drawing was not good enough.

huaiqiao

chenbingjy posted on 2017-12-25 18:34 It's over. I finished drawing the board and asked my boss to check it. As a result, the boss didn't let me draw it anymore, saying that my drawing was not good enough.

From your post, I know that you are someone with less experience. There is no way, this kind of skills can only be "fed" by your actual combat. The more you do, the better it will be.

chenbingjy

huaiqiao posted on 2017-12-25 18:37 From your post, I know that you are someone with less experience. There is no other way. You can only be "fed" with skills through your actual combat. What the hell...

Please give me more guidance.

huaiqiao

chenbingjy posted on 2017-12-25 18:39 Please give me more guidance.

Others say that they are idle. This depends on you to calm down and "feed" this skill out.

generalissimo

online DRC turned it off