How do you make these snowflake dots on the AD-PCB trace?

lozoho

How do you make these snowflake dots on the AD-PCB trace? [Copy link]

These green dots are not errors, they can also be changed to other colors. I hope the experts can answer this question, thank you

qwqwqw2088

Non-error is also a warning. What rules are violated?

qwqwqw2088

Open the message panel and see

On the PCB page, click System or panels----messages----- in the lower right corner to open the message panel----view the violation details

lozoho

qwqwqw2088 posted on 2020-5-20 12:52 Open the message panel and look at the PCB page. In the lower right corner, click System or panels----messages-----Open the message panel----View the violation details...

I have already said that these dots are not errors. I can change them to white or yellow. I click reset error marker, but these dots will not disappear.

qwqwqw2088

lozoho posted on 2020-5-20 14:28 I have already said that these dots are not errors. I can change them to white or yellow. I click reset error marker and these dots will not...

What is the purpose of changing color?

The color of the warning information can be set by the software

Is the problem judged as an alarm?

Ignore general warnings

lozoho

qwqwqw2088 posted on 2020-5-20 14:31 What is the purpose of changing the color? Can the color of the alarm information be set to determine whether the problem is an alarm? Ignore general alarms...

This is not a warning signal. This is a sign. I already know how to make it.

aowei123

Is it similar to grid points? It seems to be set up, and it should be a copper shape selection, which can be mesh points, strips, etc.!