How to set the clearance of ALTIUM without affecting the copper coating

sky999

How to set the clearance of ALTIUM without affecting the copper coating [Copy link]

If my pad spacing is 7mil, but I want the spacing between the copper and the line to be 10mil, how can I set the clearance so that it does not affect the copper?

dcexpert

Add a clearance rule

Set the rule and width

Note the precedence of rules

qwqwqw2088

Distance between copper and wire

You need to create new rules in Clearance

chenzhufly

You can also draw the line, then set the clearance, and then change it back after the copper is poured.

sky999

dcexpert posted on 2020-1-9 22:35 Add a clearance rule Set the rule and width Pay attention to the rule...

Very reliable, thanks