Rebuild Polygons correct usage

szjlcw

Rebuild Polygons correct usage [Copy link]

Whether the AD/protel software is assembling a board or you accidentally move the copper cladding during the design, how can you return to the PCB board that was not moved before?

As shown in the puzzle below:

In the Rebuild 6 Polygons? box, click No! (Because I have modified the rules, if I click Yes!, the board will not be the same as before.)

Please note the rules. At this time, if you click yes, the copper will be re-covered.

If you accidentally move the copper in the design, you should move the copper all over. It must be a complete piece. If it is out of the copper area, the re-copper window will pop up and click "no".

In this way, you will find that the original copper-covered area is very clear. Next, find a point on the detached copper-covered area and place it in the original copper-covered area. If the "Rebuild polygon" pops up, click no.