The chip is atmega64, and the emulator is USB AVR JTAGICE XPII from Weixue Electronics. The only resource used is EEPROGRAM. The thing is, after the board was adjusted, it was put down. Now when I com
The graduation project is mainly based on FPGA. You can choose the topic yourself. The difficulty is moderate. I want to do control or something like that. I hope you can give me some advice! Thank yo
[i=s]This post was last edited by dcexpert on 2016-9-13 12:31[/i] After a few days of experimentation, I finally managed to run MicroPython on the CC3200-LAUNCHXL development board. I will share the s
I want to learn about linux+arm: Can any expert tell me the specific steps to build an arm development environment under linux, what related information and tools are needed, and how to set it up? I n
Defining an interrupt service routine
#pragma vector=PORT1_VECTOR //P1 port interrupt vector__interruptvoid Port_1(void) //Declare interrupt service routine, named Port_1{... //Interrupt service routi
I have been paying attention to it online for a long time, and finally I found NET-008 to be the most practical in terms of price. You may wish to learn from its strengths. Here is its introduction:Th