• You can log in to your eeworld account to continue watching:
  • CMOS differential amplifier circuit
  • Login
  • Duration:13 minutes and 32 seconds
  • Date:2020/05/01
  • Uploader:木犯001号
Introduction
keywords: amplifier CMOS MOS
Analog Circuit Basics: From System Level to Circuit Level" closely focuses on the theme of weak signal processing circuits and organizes content from system level to circuit level. The system-level circuit teaching goal is ECG signal processing circuit design, and the circuit-level circuit teaching goal is Single-ended output two-stage operational amplifier circuit design. The course closely combines simulation experiments with theoretical teaching, organically integrating the theoretical foundation and related skills necessary for modern analog circuit engineers.
Unfold ↓

You Might Like

Recommended Posts

Create a new SENSOR debugging group
The discussion in the forum is too slow. I strongly urge everyone to join in the discussion and study: QQ group number: 22280050
manbuzhe Embedded System
[GD32F310 Review] Communication USART Configuration and ECHO Routine
Recently, I am short of time, so I will finish the serial communication program first. In this serial communication program, RX is asynchronous transmission and TX is receiving end, which is realized
javnson GD32 MCU
Which one is better, Altium Designer or Protel 99se?
I have only used protel 99se but I heard that altium designer is very good, so I plan to change protel to altium designer. Do you think it is necessary? If you have used it, please share your experien
zl_felix PCB Design
[ESP32 Learning] Using TF Card in SDIO Mode
Last week, we introduced how to use a TF card on the ESP32 learning board. However, because the resistors on the development board were not soldered, the use of the TF card was affected. Therefore, we
dcexpert MicroPython Open Source section
Drive AT080TN52 LCD
Recently I used a test box at school. The chip is CYCLONE III, and there is an AT080TN52 TFT LCD on it. I want to use VHDL to directly drive and display an image, but I don't know how to achieve it. P
huyinggang1982 FPGA/CPLD
Beginner's guide to FPGA (2): The second small mistake I encountered - about simulation (EEFPGA learning plan)
I wrote a 2-to-1 multiplexer in VHDL. After compiling, I created a new "vector waveform file" to practice waveform simulation, and found that the output waveform seemed to have a time delay. After loo
zl_felix EE_FPGA Learning Park

Recommended Content

可能感兴趣器件

EEWorld
subscription
account

EEWorld
service
account

Automotive
development
circle

About Us Customer Service Contact Information Datasheet Sitemap LatestNews


Room 1530, 15th Floor, Building B, No.18 Zhongguancun Street, Haidian District, Beijing, Postal Code: 100190 China Telephone: 008610 8235 0740

Copyright © 2005-2024 EEWORLD.com.cn, Inc. All rights reserved 京B2-20211791 京ICP备10001474号-1 电信业务审批[2006]字第258号函 京公网安备 11010802033920号