• You can log in to your eeworld account to continue watching:
  • Smoke sensor MQ-2 experiment
  • Login
  • Duration:7 minutes and 32 seconds
  • Date:2017/12/02
  • Uploader:老白菜
Introduction
  The role of Arduino is to sense the environment through various sensors, and to feedback and influence the environment by controlling lights, motors and other devices. The microcontroller on the board can be programmed using the Arduino programming language, compiled into a binary file, and burned into the microcontroller. Compared with various microcontrollers, the biggest advantage of this system is that it is very simple to use, just like building blocks. Even primary school students can quickly master Arduino and use it to make various inventions. Isn’t it interesting?

Unfold ↓

You Might Like

Recommended Posts

Friends, tomorrow is the Dragon Boat Festival. Are you happy?
The greatest blessing for a person is inner peace and stability. The more impetuous you are, the better time it is to practice. Even if you can eat zongzi tomorrow, you have to hold back your exciteme
wanghlady Talking
Asking for advice on the MAX485 hardware delay-free circuit
I've been using a 485 hardware delay-free circuit recently, but there are some problems in actual use.When using a logic analyzer to analyze data (from top to bottom, TX, DE, TE, and RX), after the Mo
tangyinyin123 Analog electronics
STM32 driving method of WS2812 lamp beads (Part 3)——DMA+SPI
In the previous section, we introduced the most common and most expected method of controlling WS2812 with STM32, which is to use PWM to control the signal and transmit the array data through DMA to e
通宵敲代码 DIY/Open Source Hardware
MOSFET溫升的計算工具
czf0408 Power technology
Pin-regulated 8mA output amplifier
I recently used the Howland constant current source circuit. The amplifier is LMV614. The output currents are 0.5ma, 1ma, 3ma, and 5ma. However, when I finished drawing the board and tested it, I foun
轩辕默殇 Power technology
Capacitor charging and discharging formula
The power supply charges the capacitor through a resistor (the charging current changes with time): Vt="E"*[1-exp(-t/RC)] The fully charged capacitor discharges through a resistor (the discharge curre
Jacktang Analogue and Mixed Signal

Recommended Content

Hot VideosMore

Circuit

可能感兴趣器件

EEWorld
subscription
account

EEWorld
service
account

Automotive
development
circle

About Us Customer Service Contact Information Datasheet Sitemap LatestNews


Room 1530, 15th Floor, Building B, No.18 Zhongguancun Street, Haidian District, Beijing, Postal Code: 100190 China Telephone: 008610 8235 0740

Copyright © 2005-2024 EEWORLD.com.cn, Inc. All rights reserved 京B2-20211791 京ICP备10001474号-1 电信业务审批[2006]字第258号函 京公网安备 11010802033920号