logo Training

Minimizing Switching Regulator Carryover in Linear Regulator Outputs

Total of 1 lesson ,4 minutes and 59 seconds
Profile

Linear regulators are often used to post-regulate the output of a switching regulator. Benefits include improved stability, accuracy, and transient response performance as well as reduced output impedance. Ideally, along with these performance improvements, the ripples and spikes produced by the switching regulator will be significantly reduced. Virtually all linear regulators encounter some difficulties involving ripple and spikes, especially as frequency increases. This video is excerpted from Linear Technology's Application Note 101, which explains the causes of dynamic limitations of linear regulators and introduces board-level techniques to measure and improve ripple and suppress spikes.

You Might Like

Recommended Posts

Basic RC Integrator Circuit and Principle Analysis
The resistor R and capacitor C are connected in series to the input signal VI, and the capacitor C outputs the signal V0. When the value of RC (τ) satisfies the input square wave width tW: τ>>tW (gene
fish001 Analogue and Mixed Signal
【ST NUCLEO-H743ZI Review】(3)Ethernet to Serial Port Test
[i=s]This post was last edited by dsjsjf on 2019-3-1 11:16[/i] [url=https://en.eeworld.com/bbs/elecplay/content/103]The development board ST NUCLEO-H743ZI evaluated in this event is provided by STMicr
dsjsjf stm32/stm8
What is the relationship between the speed ratio of the reduction mechanism and the lever ratio? What is the relationship between the force of the first gear and the last gear?
What is the relationship between the speed ratio of the reduction mechanism and the lever ratio? What is the relationship between the force of the first gear and the last gear?For example, in the figu
一沙一世 stm32/stm8
Question about ADC
The software uses ADC (ESP-12) to read the voltage and it reads 1V, but when it is measured with an ammeter or oscilloscope, it is only 0.5V. At this time, the voltage read by ADC will also become 0.5
hau30729 Analog electronics
BlueNRG-LP related information
The BlueNRG-LP Bluetooth Low Energy wireless system-on-chip is an ultra-low power, programmable solution with a 2.4GHz advanced RF radio IP for ultra-low latency applications. The BlueNRG-LP SoC compl
littleshrimp ST - Low Power RF
Android boot execution shell script
宋体][b][color=rgb(51, 51, 51)][font=微软雅黑][size=18pt]Android executes shell script at startup[/size][/font][/color][/b][b][color=rgb(51, 51, 51)][/color][/b][/b][align=left] [/align][align=left][font=宋体
明远智睿Lan Industrial Control Electronics
Recommended Content
Web users are watching Change

EEWorld
subscription
account

EEWorld
service
account

Automotive
development
circle

About Us Customer Service Contact Information Datasheet Sitemap LatestNews


Room 1530, 15th Floor, Building B, No.18 Zhongguancun Street, Haidian District, Beijing, Postal Code: 100190 China Telephone: 008610 8235 0740

Copyright © 2005-2024 EEWORLD.com.cn, Inc. All rights reserved 京B2-20211791 京ICP备10001474号-1 电信业务审批[2006]字第258号函 京公网安备 11010802033920号