Training
Profile
The microcontroller (MCU) series based on Atmel|SMART SAM D ARM Cortex-M0+ embodies Atmel's decades of innovative ideas and rich experience in embedded flash microcontroller technology. It not only sets new benchmarks in flexibility and ease of use, but also combines the high performance and efficiency of ARM Cortex-M0+ based MCUs with an optimized architecture and peripheral set. Atmel|SMART SAM D brings you a truly distinctive general-purpose microcontroller ideal for many low-power, cost-sensitive enterprise and consumer applications.
You Might Like
Recommended Posts
- Silicon Labs Development Kit Review + Development Board Arrives
- [i=s]This post was last edited by yin_wu_qing on 2021-7-24 12:04[/i]I received the EFM32PG22 development kit yesterday. The development board is indeed very fine, with a length of 4.5cm and a width of
-
yin_wu_qing
Development Kits Review Area
- MicroPython and CircuitPython installation package tool pipkin
- DescriptionTool to install distribution packages for MicroPython and CircuitPython.Supportsupip-compatible packagesand regular pip-compatible packages (by usingpip install --target ...).By default it
-
dcexpert
MicroPython Open Source section
- filter
- Why must the coefficient of the first-order term s in the denominator of formula (6.3.14) in the figure be greater than zero for the circuit to operate stably?
-
1nnocent
Analog electronics
- Looking for a company that can make SIC simulation models
- The project requires a company that can make SIC simulation models. The impedance, on-delay, parasitic capacitance and other parameters must be adjustable. Can you recommend a capable company?
-
sanhuasr
Motor Drive Control（Motor Control）
- The volume control IC PT2259 has background noise, how to solve it?
- The volume control IC PT2259 has background noise, how to solve it? Through the encoder potentiometer control, the noise does not change after the volume is turned off.Please help me, provide a soluti
-
yangyong1234
Analog electronics
- How to overcome the load-pull measurement challenges of 5G mmWave? (Part 2)
- [i=s]This post was last edited by alan000345 on 2019-5-27 10:04[/i] [p=25, null, left][color=rgb(51, 51, 51)][font=微软雅黑]Active Load Pull[/font][/color][/p] [p=25, null, left][color=rgb(51, 51, 51)][fo
-
alan000345
RF/Wirelessly
Recommended Content
Web users are watching Change
- Silicon Labs Development Kit Review + Development Board Arrives
- MicroPython and CircuitPython installation package tool pipkin
- filter
- Looking for a company that can make SIC simulation models
- The volume control IC PT2259 has background noise, how to solve it?
- How to overcome the load-pull measurement challenges of 5G mmWave? (Part 2)
- [National Technology N32G430] 4GPIO inversion
- Computer World has been eliminated by the computer world! Do you still read paper magazines/newspapers?
- EEWORLD University - Getting Started from the Ground Up: Teach You How to Quickly Develop MSP430 Projects
- Free evaluation - Topmicro intelligent display module (1) Receive module
- TI has integrated it! CAN FD strengthens and upgrades automotive neural networks
- EEWORLD University - Key Considerations for Isolated CAN Transceivers
- Application of Dacai UART screen in smart filing cabinet
- Please help me find out what circuit the box in the attached picture is.
- New content for the Dragon Boat Festival Core Points redemption! Selected Zongzi for everyone to redeem!
- TMS320F280049C Learning-GPIO
- 【FAQ】A brief discussion on Microchip's FPGA products and intelligent embedded vision solutions
- There are already over 300 CircuitPython libraries
- Is LDO a DC/DC?
- [TI recommended course] #[High Precision Lab] Clock and Timing#
- How do you estimate the number of vias on the capacitors in the power supply section of a PCB? Do you need to drill a lot of vias if the capacitors don't carry a lot of current?
- The blueNRG-1 chip will burn out automatically when running the program (solved)
- Application of DSP repetitive control technology in inverter power supply system
- Regarding the calculation of the values of TA0CCR1 and TA0CCR2 configured by the PWM library function
- What does the Y axis of the graph displayed by the baud meter mean? For example, if it starts at 5DB and ends at -100DB, how do you understand it? Attenuation signal...
- Ask SAMD21 question
- LORA SX1308
- Newbie question: When using the PCB antenna library, one of the antenna pins is not connected. I want to know how to solve it.
- Why is this power circuit connected like this?
- 【National Technology N32G430】03 Development foundation, the platform is emerging
Popular Components
Just Take a Look
Hot Downloads
- MK_Research on High Sensitivity Fiber Optic Gas Sensor.pdf
- It is cross sample entropy codeIt will be helpful for nonlinear dynamics
- Research and implementation of wireless personal area network based on Bluetooth Ethernet encapsulation technology
- Precision Signal Conditioning Basics
- [Data]-JIS B6202-1998 General purpose parallel lathe accuracy test 1.pdf
- Railway communication power supply microcomputer monitoring system based on ATmega128 single chip microcomputer
- Counter within 1000
- Journal article: Image retrieval technology based on compressed domain
- Research on sensorless control strategy of permanent magnet synchronous motor in full speed range
- RANSAC algorithm and its various improved algorithms
MoreHot Articles
- LED chemical incompatibility test to see which chemicals LEDs can be used with
- Application of ARM9 hardware coprocessor on WinCE embedded motherboard
- What are the key points for selecting rotor flowmeter?
- LM317 high power charger circuit
- A brief analysis of Embest's application and development of embedded medical devices
- Single-phase RC protection circuit
- stm32 PVD programmable voltage monitor
- Introduction and measurement of edge trigger and level trigger of 51 single chip microcomputer
- Improved design of Linux system software shell protection technology
- What to do if the ABB robot protection device stops
京公网安备 11010802033920号