logo Training

Getting Started with Atmel SAM D Design - How to Configure UART

Total of 1 lesson ,7 minutes and 24 seconds
Profile

This video explains step by step how to configure the UART in SAM D10 (ARM Cortex-M0) in the Studio development environment.

You Might Like

Recommended Posts

About CCSv4 Chinese Tutorial
Beginners like me who want to learn CCSV4 can take a look at this small tutorial first, it may be helpful to you.
zhao5476278 Microcontroller MCU
keil
zgjian Embedded System
stm32usb download software
When downloading a program, the chip always times out and responds, and the download fails. What's going on?
陈彬超 stm32/stm8
Analysis of variable frequency oscillators
Please help me figure out how to analyze this. How are the capacitance and resistance calculated? The above fixed values are not correct. The book does not give fixed values. How should I calculate it
jim101 Analog electronics
DSP2407 PWM waveform output is unstable
I use the full comparison unit to output PWM square waves. It works fine on the development board. The frequency does not change, but the amplitude sometimes changes. However, it does not affect the c
guijinwen Embedded System
Help, about the operation of ADXL345!
Hello everyone: I need to use the ADXL345 gravity sensor in my work recently, so I am working hard to learn it. But since it is my first time using this sensor, there are still some problems that I ca
梦想时刻 Microcontroller MCU
Recommended Content
Web users are watching Change

EEWorld
subscription
account

EEWorld
service
account

Automotive
development
circle

About Us Customer Service Contact Information Datasheet Sitemap LatestNews


Room 1530, 15th Floor, Building B, No.18 Zhongguancun Street, Haidian District, Beijing, Postal Code: 100190 China Telephone: 008610 8235 0740

Copyright © 2005-2024 EEWORLD.com.cn, Inc. All rights reserved 京B2-20211791 京ICP备10001474号-1 电信业务审批[2006]字第258号函 京公网安备 11010802033920号