I opened the Remote Performance Monitor of pb 6.0 and connected to the device via kitl, but the Remote Performance Monitor showed nothing. I selected Edit | Add to Chart. The default objects displayed
GD32F105RBT6 and STM32F103RBT6 are fully compatible, not even a pin difference. The interface for downloading programs is also the same. Can I directly use the program in the original STM32? Are they
Hello everyone, I have a question, how to send MMS using AT command under GPRS? I hope some experts can give me some advice, what is the encoding (picture) of MMS, is it still Unix encoding? Can you g
Table of Contents
1. A journey of a thousand miles begins with a single step .................................. 4 2. A good worker must first sharpen his tools before he can do his work well .........
The circuit board has debugged the correct signal (a sine wave with a certain duty cycle). After connecting the motor (2 wires, black-ground, red-drive signal), the motor does not move and the signal
[i=s]This post was last edited by liutogo on 2015-8-16 10:25[/i] I received a sample from Ti yesterday. First of all, thank you Ti. After such a long time in school, I am used to looking for solutions