The attached picture is my SPLL model. I have some questions. When the output of the integrator reaches 2PI, the integrator is reset to zero. How should I modify this model? Also, how should I discret
Are you confused about gate drivers? Infineon Technologies has the answer! You can also get a 50-yuan Jingdong card and 10 free development boards.Event time: From now until July 4thActivity 1: Answer
Note: Unless otherwise specified, all prime values are measured at 20°C.
(α) at 100°C. (β) at 0°C. (a) || to three axes.
(b) ⊥ to the three axes.
(c) Average value; graphite varies from 2.0 to 5.6 dep
[color=rgb(0,0,0)]I use Altium Designer 10 to draw a PCB. I want to draw a wire from a pad to another place. But the wire always starts from the center of the pad. Even if I uncheck the "Capture" chec