Self-made 3D connector package library: DB25-F-PCB layout-EEWORLD

Recommended ContentMore

Open source project More

Searched by Users

Just Take a LookMore

Review Weekly Report 20220606: Qinhengjia invites you to try Type-C fast charging chip CH224. Can it be used at low cost and even if you are not familiar with PD?
This issue highlights: -Newly launched Qinheng type-c fast charging chip ch224, you can use it without being familiar with PD - Last 8 days to apply for National Technology's low-power MCU evaluation
Let's talk about some issues of microcontroller IO expansion
Friends who study MCU know that the number of IO ports of MCU is fixed. When doing a project, we need to consider the number of IO ports we actually use and the hardware resources of the MCU. We will
[Review of SGP40] Rapid deployment of an AI-powered ambient air quality tracking model #2 Power-on test with Arduino
1. After unpacking and getting the information, start testing with Arduino code. For specific connections, please refer to the previous post. You can connect UART as shown in the figure below, where U
When adding a 10M ohm feedback resistor to the OPA314 sensor signal amplifier circuit, 50HZ signal interference occurs. What is the reason?
When adding 10M ohm feedback resistor to the OPA314 sensor signal amplifier circuit, 50HZ signal interference occurs. What is the reason?When the feedback resistor is changed to 100K, the signal inter
EEWORLD University ---- Jixin STM32 Smart Car
Jixin STM32 Smart Car : https://training.eeworld.com.cn/course/5525Explain the design and production of smart cars based on STM32 in modules, and analyze the code
【Qinheng RISC-V core CH582】Development board evaluation summary
Experience in using PWM of 28069 and 28377D of C28x series
Microwave Circuit Rules of Thumb
How to connect CVBS and LVDS video signals to the meter screen of Audi S5.
Let’s practice together in 2021” + It’s no big deal, pack up and go again

Trending Downloads

Self-made 3D connector package library: DB25-F

Document Introduction