Journal article: Multi-target segmentation based on Mumford-Shah model-Others-EEWORLD

Recommended ContentMore

Open source project More

Searched by Users

Just Take a LookMore

220V AC to 18V DC
Using a 220V to 18V transformer, the voltage output of the transformer output (pins 12, 14, 17, 19) is 12V. After passing through the MB6S rectifier, the output voltage of pin 3 of SP1 is 27V, and the
DSPF28335 Study Notes
[i=s]This post was last edited by Aguilera on 2018-12-24 20:41[/i] [size=4]1. GPIO[/size] [size=4]GPxMUX (function selection register),[/size] [size=4] GPxMUX.bit=0 is configured as I/O function. GPxM
Anyone know what component this is?
I don't know what this capacitor is.
【AT-START-F425 Review】-Recording the use of CAN communication
【AT-START-F425 Review】- Recording the use of CAN communicationCAN communication pinAccording to the chip manual, AT32F425 PB8 = CAN_RX PB9 = CAN_TXmultiplexed port is MUX4Check the Demo project and co
HDI blind hole design, did you notice this detail?
Author: Wang Huidong, member of Mr. Expressway of Yibo Technology Rao Xiaoxiao said: I love three things: the sun, the moon, and the circuit board.A Mao said: I'll just take a look.A Mao, who had just
【TI recommended course】#Give old motors new skills#
This is a brain teaser - hypotenuse, leg, chord, even Pythagorean theorem
Should the PCB trace angle not be 90°? — PCB Layout Tips
Problems with serial programming of STC89C51RC microcontroller
【ST NUCLEO-H743ZI Review】+ 2. LED Flowing Light

Trending Downloads

Journal article: Multi-target segmentation based on Mumford-Shah model