Designers implement current sensing for system protection and monitoring by placing a very small "shunt" resistor in series with the load and a current sense amplifier or op amp between the two. While
[i=s]This post was last edited by TEL18688947970 on 2021-7-26 11:13[/i]Lingdong Microelectronics is a leading Chinese supplier of general-purpose 32-bit MCU products and solutions. Lingdong Microelect
The DSP28335 GPIO module is divided into three types of IO ports: PORTA (0-31), PORTB (32-63), and PORTC (64-87). The settings of the GPIO module are mainly completed through three types of registers,
This is probably the best analog engineer's circuit design guide + a compilation of blog posts on op amp design topicsTo simplify and speed up system design, TI's "Circuit Design Cookbook for Analog E
1. Zener diodes are generally used as reference power supplies in voltage-stabilized power supplies. They work in reverse breakdown state. When using them, pay attention to the connection of positive