Method for realizing synchronization between OrCAD and PADS-Embedded Development-EEWORLD

Recommended ContentMore

Open source project More

Searched by Users

Just Take a LookMore

Why signal isolation is important in 48V HEV/EV systems
One of the main differences between a traditional internal combustion engine vehicle and a hybrid electric vehicle (HEV) or electric vehicle (EV) is the presence of multiple batteries and voltage leve
[Dialogue with forum members] Fake goods: I didn’t expect that inductors could also be fake + the FPGA I just bought has a problem with random inspection
Now, when there is no product, fake products are used to make up the rhythm? Netizens need to be careful, There are only two cases that I know of and that our forum engineers have personally experienc
IIC Timing Diagram
Please recommend a 5V to positive and negative 15V op amp power supply circuit or chip to share
Convert USB power supply to positive and negative 15V power supply, which can power 3 op amps. The power consumption of op amp is about 300MW, which should be enough. Please recommend related circuits
Lock-in Amplifier Design
I am a newbie, and I want to make a phase-locked amplifier with a reference signal frequency of 5MHz~7MHz. I have checked some information but still have no idea. Can any expert give me some advice?
EEWORLD University ----RISC-V 5th workshop
What is transparent transmission and point-to-multipoint transmission? What are their classic applications and advantages?
How to build an undervoltage protection circuit using discrete components
[Mill MYB-YT507 development board trial experience] + some problems in the compilation experience
How to configure the pins used by LCD as GPIO?

Trending Downloads

Method for realizing synchronization between OrCAD and PADS

Document Introduction