Design of Bluetooth products based on low power consumption characteristics of MSP430

Recommended ContentMore

Open source project More

• Single channel lithium iron phosphate charger
• 【ART-Pi】Local speech recognition control
• OM13088: LPCXpresso4367 development board
• DER-30 - 3.3W non-isolated flyback converter
• [Internet of Things] Hongmeng Smart WiFi Switch +4236682A
• DER-442 - 30W Isolated Flyback, 1 - 10 V Analog Dimmable LED Driver
• Expansion board schematic diagram
• Zhou Ziqi1810300239 practical course homework
• 74HC4052 analog switch module
• C2979601_CH9121-based serial port to Ethernet solution verification board

Searched by Users

• Cracked version of ModBusPoll.4.3.4+Slave+Cracked version of virtual serial port assistant
• Power Integrity Modeling and Design for Chips and Systems PDF Document
• AC current measurement system based on STM32 (program, circuit data)
• Infineon Technologies Tricore User Manual (Full)
• Self-made package library: TSSOP20
• 80c51 based on keil4 control electric fan
• Pads2005 green version, please support environmental protection
• EN ISO15614-2 Chinese version
• Allegro16.6 Training Tutorial (Chinese Version) Simplified
• G711 G721 G723 audio codec program

Just Take a LookMore

• AD drawing PCB has many white lines after enlarging
  When the AD PCB is enlarged, there are many white lines, not flying lines, and many horizontal bars. If it is not enlarged, there are only flying lines. Please help, what is going on?
• AD Ignore DRC with irregular slotting settings using pad stacking
  [i=s]This post was last edited by p0we7 on 2019-7-30 22:44[/i]======================= Solved: It turned out that the Hold to Hold rule did not have online detection enabled, so the corresponding DRC w
• High frequency characteristics of resistors
  High frequency characteristics of resistorsWhen resistors are used in high-frequency applications, the effects of the resistor's inherent inductance and inherent capacitance must be considered. At thi
• Problems with dynamic load line locus of transistor switches
  [i=s]This post was last edited by engineer-x on 2022-2-9 17:36[/i]In the chapter on transistor switching principles in the power supply book, The book says that when an inductive load is connected, th
• Inductor ripple rate r value selection problem
  The book on power supply design describes it this way. I have many questions about the inductor current ripple rate.From this formula in the book, we know that r is related to the volt-second product,
• BOX unpacking test
• EEWORLD University Hall--Understand the development history of smart home in one minute (video)
• "Playing with the board" + Yu Zhennan's STM32 development board experiment 2
• [CH579M-R1] + Help: Unable to drive LSM303DLH magnetic field sensor
• Soldering surface for printed circuit boards: HAL lead-free

Trending Downloads

• PCB Design Specifications for Switching Power Supplies
• Research on SVPWM Single-Phase Inverter System Controlled by DSC
• Principle and Application of Petri Net
• nmd fault code
• Simulation Analysis of Buck-Boost Converter
• Very thorough analysis - anti-motivation handouts
• Good design experience
• Design and Application of CAN Bus Isolator
• AVR MCU fuse settings and detailed rescue methods
• Bluetooth Technology Overview (3).files.rar

Trending ArticlesMore

• Breaking news! The Big Fund reduced its holdings of SMIC by 100 million shares...
• Texas Instruments Inc. announces third quarter 2017 financial results and shareholder returns
• It’s Chinese New Year! Fuck! Some funny Linux commands
• Microchip Launches Model 53100A Phase Noise Analyzer to Help More Accurately Characterize Various Oscillators
• Make complex applications worry-free and leave it to AMPLIMITE D-Sub connectors!
• The highest AI score in history! Google's big model sets a new record for US medical license exam, with scientific knowledge comparable to that of human doctors
• In just 10 years, South Korea built a chip center
• Core News Express | The future of payment starts with wearable devices and smart speakers
• Walden International Partner Wang Lin Talks about the Hardships and Confidence of Chinese Semiconductor Investment