1 Output mode 0 Output mode: The output signal OUTx is defined by the OUTx bit in the control register CCTLx of each capture/compare module and is updated immediately after writing to this register. T
Hello everyone, I want to make a sound signal delayer, that is, the signal from the front end is delayed by about 0.5 to 1s before being transmitted to the back end, trying to ensure that the sound is
As shown in Figure 1, we can see a 485 self-transceiver circuit. Figure 2 is the PIN definition of the 485 chip. During the data transmission process, when TXD sends 0, the transistor is not turned on
[align=left][font=微软雅黑][size=4][b]The development board mobile station has added a new board: the STM32F723 Discovery Kit. First, a brief introduction to the board: [/b][/size][/font][/align] [align=l
[i=s]This post was last edited by Beifang on 2022-9-13 22:19[/i]EEWorld invites you to disassemble (sixth issue): disassemble the car wireless charger - Power Technology - Electronic Engineering World