Tutorial on using 51 MCU chip on K18 development board-Embedded Development-EEWORLD

Recommended ContentMore

Open source project More

Searched by Users

Just Take a LookMore

Strange phenomenon of screen display and USB!
Let me first talk about the operating environment. The screen display uses the TouchGFX framework, the USB uses HID mode, the operating system is RTThread, and the microcontroller is the STM32H7 serie
50 ohm impedance line problem
As shown in the picture above, if we want to make a 50 ohm impedance line, do we need to make both the lighted sections? Or just the bottom section?If I make both sections and connect them with a 0 oh
【Portable programmable instrument】Begin preparation for debugging
With the help of my colleagues, I soldered the PCB and started debugging.USB Interface BoardPower BoardMCU BoardAssembled together
TIOBE Programming Language Rankings April 2022
For the first time in more than 10 years, MATLAB is about to fall out of the top 20. Since MATLAB licenses are quite expensive, alternatives are now catching up quickly. Its main competitors are Pytho
Selection of Serial Port to WiFi Module and Serial Port to Network Port Module for Industrial Control Gateway of Internet of Things
With the development of the Internet of Things, the physical layer of the initial two machines directly communicating through hardware to the data link layer communicating in the local area network th
TI Cortex MCU Industrial Safety Applications
[Raspberry Pi Pico Review] WS2812B Snowflake Light Practice -- and IoT Communication RGB Control
How to convert a sine wave into a square wave
If you want to work in electronics, you need to remember these English words!
Decoupling Technology

Trending Downloads

Tutorial on using 51 MCU chip on K18 development board

Document Introduction