Large model details-Others-EEWORLD

Recommended ContentMore

Open source project More

Searched by Users

Just Take a LookMore

May I ask what IDE was used to create the project with the extension MPJ? See the picture below.
May I ask what IDE was used to create the project with the extension MPJ? See the picture below.
Please tell me, can this diagram realize a bistable circuit?
[i=s]This post was last edited by sky999 on 2021-3-8 06:18[/i]Pin 4 of 1308 is the enable pin. It works when it is greater than 1.5V and stops when it is less than 0.4V. I want to achieve output when
BlueNRG-1 electronic ID card communication
I want to make an electronic ID card based on BlueNRG-1. I want to send and upload identity data to and from Android. The number of electronic ID cards can be supported to be around 100, all online at
STM32 MCU realizes serial port 1 (115200) to receive/send data to serial port 2 (9600) at the same time
stm32g030 chip Implement the function of sending data from serial port 1 to serial port 2 and receiving data from serial port 2 at the same timeSerial port 2 sends data to serial port 1 and receives d
"【TGF4042 Signal Generator】" Dual-channel signal measurement
Hello everyone! According to the plan, the output signal power should be measured this week, but unfortunately, I just found that the output signal power of this signal source cannot be set, only the
MSP430F5529 initialization channels and pins
Design of low voltage dropout buck regulator circuit
Bluetooth Air Capture
Analysis of ZIGBEE report mechanism
2020-4-14-Verify the results of the moderator's suggestion

Trending Downloads

Large model details