DESCO INDUSTRIES INC TECHNICAL BULLETIN TB-7041
Statguard
®
Dissipative Neutral Floor Cleaner
Application Instructions
Made in the
United States of America
EQUIPMENT NEEDED:
• Push broom
• Clean and untreated mop
• 2 dedicated buckets
(Clean bucket and rinse bucket)
• Statguard
®
Dissipative Neutral Floor Cleaner
1. Push broom the surface to be cleaned.
2. For damp mop, dilute Statguard
®
Dissipative
Cleaner 10 to 1 (five (5) gallons of clean water to
two (2) quarts of cleaner concentrate). For scrub
use 15 to 1.
3. Thoroughly mix the cleaner solution before damp
mop application. Use a clean, untreated mop to
damp mop the area. Wring out excess fluid and do
not flood a treated floor with water. For a scrubbing
machine use 175 to 350 RPM with red pad.
4. Allow 30 to 60 minutes drying time before walking
on the cleaned area.
Clean floors treated with Statguard
®
Floor Finish using
Statguard
®
Cleaner. Do not damp mop with high alkaline
or high residue cleaner. Using harsh detergents can
damage a treated floor's static dissipative properties.
Figure 1. Statguard
®
Dissipative Neutral Floor Cleaner
Description
Statguard
®
Dissipative Neutral Floor Cleaner is
formulated to clean floors treated with
Statguard
®
Dissipative Floor Finish
and
Statguard
®
Low-VOC
Dissipative Floor Finish,
as well as other dissipative or
conductive floor tiles and polymer type floor finishes.
It is formulated with dissipative agents that will
rejuvenate and improve the static dissipative properties
of the flooring surface that it is used with without
leaving behind residue that can impede dissipation or
conductive properties of the flooring material or finish.
Physical Properties
% Solids
pH
Color
Order
Coverage
10%
7.0
Green
Floral
20,000 sq.ft./gal. of
concentration
30 - 60 min. @ 55% RH
1 x 10
6
to < 1 x 10
9
ohms per
ANSI/ESD STM7.1 and ESD
TR53
Application
The Statguard Dissipative Neutral Floor Cleaner is
more aggressive than using a damp mop with a diluted
finish and water and does reduce the gloss down as
it cleans the surface. Heavy to moderate traffic floors
can be cleaned once a week. Light traffic floors can be
cleaned 2 to 3 times a month or as needed.
®
Freeze/Thaw Stability
Passes three cycles
Drying Time
Surface Resistivity
Testing a small area for compatibility if Statguard
Dissipative Neutral Floor Cleaner has not been used
before is recommended.
®
Storage
Statguard
®
Dissipative Neutral Floor Cleaner does not
have a set life span. The chemicals are not known
to degrade over time when stored at the proper
temperature conditions as stated in the Safety Data
Sheet. We also recommend that the product be stored
in its original container and be sealed when not in use.
DESCO INDUSTRIES INC
- 3651 Walnut Avenue, Chino, CA 91710 • (909) 627-8178 • Website:
DescoIndustries.com
TB-7041
Page 1 of 8
July 2018
© 2018 DESCO INDUSTRIES INC
Employee Owned
RoHS, REACH, and Conflict Minerals Statement
See the Desco Industries RoHS, REACH, and Conflict
Minerals Statement:
DescoIndustries.com/ROHS.aspx
Desco Industries Limited Warranty
See the Desco Industries Limited Warranty:
DescoIndustries.com/Warranty.aspx
Statguard
®
Dissipative Neutral Floor Cleaner is available
from these Desco Industries brands:
for service and support in North America
2.5 Gallons
5.0 Gallons
10561
10566
for service and support in North America
2.5 Gallons
5.0 Gallons
46030
46031
for service and support in United Kingdom and
Europe
10 Litres
220522
for service and support in Asia
10 Liters
20 Liters
10561
10566
DESCO INDUSTRIES INC
- 3651 Walnut Avenue, Chino, CA 91710 • (909) 627-8178 • Website:
DescoIndustries.com
TB-7041
Page 2 of 8
© 2018 DESCO INDUSTRIES INC
Employee Owned
SAFETY DATA SHEET
May be used to comply with OSHA Hazcom 29 CFR 1910.1200, Reg. (EU) No.453/2010 and Japan JIS
7253-2012). Standards must be consulted for specific requirements.
Revision Date:
2018-07-02
SECTION 1 — IDENTIFICATION OF THE SUBSTANCE/MIXTURE AND OF THE COMPANY/UNDERTAKING
1.1 Product identifiers
Product Name:
EC No.:
REACH Registration No.:
CAS No.:
Identified use:
Supplier:
United States
One Colgate Way
Canton, MA 02021
+1 781-821-8370
Email Address:
1.4 Emergency telephone number
United States:
United Kingdom:
Japan:
Office hours:
8:00 AM - 5:00 PM
Statguard
®
Dissipative Neutral Floor Cleaner
None
None
None
Cleaner, Floor
DESCO INDUSTRIES INC
United Kingdom
2A Dunhams Lane
Letchworth Garden City
Hertfordshire, SG6 1BE
+44 (0) 1462 672005
Service@DescoIndustries.com
+1 781-821-8370
+44 (0) 1462 672005
+81 43-309-4470
Japan
661-1 Yachimata-ho
Yachimata-Shi
Chiba-Ken 289-1115
+81 43-309-4470
1.2 Relevant identified uses of the substance or mixture and uses advised against
1.3 Details of the supplier of the safety data sheet
SECTION 2 — HAZARDS IDENTIFICATION
2.1 Classification of substance or mixture
Classification according to OSHA Hazcom 29 CFR 1910.1200, Regulation (EC) No 1272/2008, JIS 7252-2014
Acute toxicity (Oral)
Skin Corrosion/irritation
Serious eye damage/eye irritation
Category 4
Category 2
Category 2A
2.2 Label elements
Classification according to OSHA Hazcom 29 CFR 1910.1200, Regulation (EC) No 1272/2008, JIS 7252-2014
Hazard pictograms/Symbols:
Signal word:
Hazard statements:
Precautionary statements:
Warning
H302 Harmful if swallowed
H315 Causes skin irritation
H319 Causes serious eye irritation
Prevention
P264 Wash exposed skin thoroughly after handling.
Response
P301 + P312 + P330 IF SWALLOWED: Call a POISON CENTER or
doctor/physician if you feel unwell. Rinse mouth.
P332 + P313 IF skin irritation occurs: Get medical advice/attention.
DESCO INDUSTRIES INC
- 3651 Walnut Avenue, Chino, CA 91710 • (909) 627-8178 • Website:
DescoIndustries.com
TB-7041
Page 3 of 8
© 2018 DESCO INDUSTRIES INC
Employee Owned
P305 + P351 + P338 + P337 + P313 IF IN EYES: Rinse cautiously with
water for several minutes. Remove contact lenses, if present and easy to
do. Continue rinsing. If eye irritation persists: Get medical advice/attention.
Storage
P501 Dispose of contents and container to an approved waste disposal
plant.
2.3 Other hazards
N/A
SECTION 3 — COMPOSITION/INFORMATION ON INGREDIENTS
3.2 Mixture
Components
Lithium Chloride
CAS No.
7447-41-8
%wt.
5 - 25%
Classification
OSHA 29CFR 1910.1200:
Flammable liquids - Category 3
Skin corrosion - Category 1A
Serious eye damage/eye irritation - Category 1
Reg. (EC) No. 1272/2008:
Acute tox. (Oral) - Category 4
Skin irritation - Category 2
Eye irritation - Category 2
JIS 7252-2014:
Acute tox. (Oral) - Category 4
Skin irritation - Category 2
Eye irritation - Category 2A
SECTION 4 — FIRST AID MEASURES
4.1 Description of first aid measures
Eye Contact
Skin Contact
Ingestion
Flush with water for at least 15 minutes. If irritation occurs and persists,
contact a doctor.
Wash with plenty of soap and water. If irritation occurs and persists,
obtain medical attention.
Drink 1 or 2 glasses of water and induce vomiting by touching the back of
the throat with a finger or by giving syrup of ipecac. Never induce vomiting
or give anything by mouth to an unconscious person. Contact a doctor.
Remove to fresh air. If breathing difficulty or discomfort occurs and per-
sists, obtain medical attention.
Inhalation
4.2 Most important symptoms and effects, both acute and delayed
No further relevant information available.
4.3 Indication of any immediate medical attention and special treatment needed
No further relevant information available.
SECTION 5 — FIRE FIGHTING MEASURES
5.1 Extinguishing media
Suitable Extinguishing Media
Unsuitable Extinguishing Methods
The product is non-combustible. Dry chemical, CO2, water spray or
regular foam.
N/A
5.2 Special hazards arising from the substance or mixture
Components of this product may decompose in a fire and produce irritating fumes and toxic gases.
5.3 Advice for firefighters
Wear full protective clothing and self-contained breathing apparatus approved for fire fighting. This is necessary to
protect against the hazard of heat, products of combustion and oxygen deficiency. Do not breathe smoke, gases or
vapors generated.
DESCO INDUSTRIES INC
- 3651 Walnut Avenue, Chino, CA 91710 • (909) 627-8178 • Website:
DescoIndustries.com
TB-7041
Page 4 of 8
© 2018 DESCO INDUSTRIES INC
Employee Owned
SECTION 6 — ACCIDENTAL RELEASE MEASURES
6.1 Personal precautions, protective equipment and emergency procedures
Wear protective clothing. Inhalation protection. Extinguish all ignition sources.
6.2 Environmental precautions
Keep spills and cleaning runoffs out of municipal sewers and open bodies of water.
6.3 Methods and materials for containment and cleaning up
Soak up with sawdust, sand, or other absorbent material. Shovel or sweep up. Flush spill area with water. Properly
dispose of solid waste.
Spill: Mop up spills immediately. Wet floor may present slip hazard.
6.4 Reference to other sections
See SECTION 13, Disposal Considerations, for information regarding the disposal of contained spills.
SECTION 7 — HANDLING AND STORAGE
7.1 Precautions for safe handling
Use in well-ventilated areas; avoid breathing vapors. Do not eat, drink, or smoke while handling this product.
Keep containers closed when not in use. Empty containers should be handled with care. Avoid from freezing. For
commercial and industrial use only.
7.2 Conditions for safe storage, including any incompatibilities
Storage temperature: Max. 49°C/120°F - 1°C/34°F.
7.3 Specific end use(s)
N/A
SECTION 8 — EXPOSURE CONTROL / PERSONAL PROTECTION
8.1 Control parameters
If exposure limits exist, they are listed below. If no exposure limits are displayed, then no values are applicable.
Component
Lithium Chloride
CAS No.: 7447-41-8
8.2 Exposure controls
Individual protection measures
Ventilation
Protective Gloves
Provide general clean air dilution or local exhaust ventilation in volume
and pattern to prevent air contaminant concentration build-up.
If there is potential for prolonged or repeated skin contact, wear gloves for
the duration of anticipated exposure.
For EU:
In case of using gloves, use chemical resistant gloves classified
according to standard SS-EN 374: Protective gloves against chemical and
microorganisms.
In case of prolonged contact or repeated contact, it is recommended
gloves with protection index grade 4 or higher (breakthrough time longer
than 120 minutes according to standard SS-EN 374).
When only short-term contact is expected, it is recommended gloves
with protective index class 1 or higher (breakthrough time longer than 10
minutes according to standard SS-EN 374).
Avoid contact with eyes. Use safety eye wear with splash guards or side
shields.
For EU:
Safety glasses (with side shields) should be consistent with EN
166 or equivalent.
None normally required. If unable to avoid prolonged or repeated contact
with skin, wear protective clothing.
Wash hands before eating, smoking, or using washroom facilities.
Regulation
ACGIH
ACGIH
OSHA Z-1
Type of listing
TWA
STEL
TWA
Value/Notation
NE
NE
15 mg/m3
Eye Protection
Other Protective Equipment
Work/Hygienic Practices
DESCO INDUSTRIES INC
- 3651 Walnut Avenue, Chino, CA 91710 • (909) 627-8178 • Website:
DescoIndustries.com
TB-7041
Page 5 of 8
© 2018 DESCO INDUSTRIES INC
Employee Owned
京公网安备 11010802033920号
EEWORLD
