5.0 mm x 3.2 mm Package Pinout ............................................................................................................................................... 1
Ordering Information .................................................................................................................................................................... 2
Device Configurations and Pin-outs ............................................................................................................................................. 9
Pin-out Top Views................................................................................................................................................................. 9
Test Circuit Diagrams for LVCMOS and Clipped Sinewave Outputs ......................................................................................... 10
Frequency Stability ............................................................................................................................................................. 16
Output Frequency and Format............................................................................................................................................ 16
Output Frequency Tuning ................................................................................................................................................... 16
Pin 1 Configuration (OE, VC, or NC) .................................................................................................................................. 17
Control Voltage Bandwidth ................................................................................................................................................. 20
Pull Range and Average Pull Range .................................................................................................................................. 22
Output Frequency ............................................................................................................................................................... 23
2
I C Control Registers .......................................................................................................................................................... 25
Serial Interface Configuration Description .......................................................................................................................... 28
Serial Signal Format ........................................................................................................................................................... 28
Parallel Signal Format ........................................................................................................................................................ 29
Parallel Data Format ........................................................................................................................................................... 29
2
I C Timing Specification ...................................................................................................................................................... 31
2
I C Device Address Modes ................................................................................................................................................. 32
Schematic Example ............................................................................................................................................................ 33
Dimensions and Patterns ........................................................................................................................................................... 34
Additional Information ................................................................................................................................................................ 36
Revision History ......................................................................................................................................................................... 37
Rev 1.05
Page 3 of 38
www.sitime.com
SiT5156
1 MHz to 60 MHz, ±0.5 to ±2.5 ppm, Elite Platform™ Super-TCXO
Electrical Characteristics
All Min and Max limits are specified over temperature and rated operating voltage with 15 pF output load unless otherwise
stated. Typical values are at 25°C and 3.3V Vdd.
Table 1. Output Characteristics
Parameters
Nominal Output Frequency Range
Operating Temperature Range
Symbol
F_nom
T_use
Min.
1
-20
-40
-40
Frequency Stability over
Temperature
Initial Tolerance
Supply Voltage Sensitivity
F_stab
–
–
–
F_init
F_Vdd
–
–
–
–
Output Load Sensitivity
F_load
–
–
–
Frequency vs. Temperature Slope
ΔF/ΔT
–
–
–
Dynamic Frequency Change during
Temperature Ramp
One-Year Aging
20-Year Aging
F_dynamic
–
–
–
F_1y
F_20y
–
–
Typ.
–
–
–
–
–
–
–
–
±7.10
±11.83
±28.40
±0.81
±1.35
±3.24
±15
±25
±60
±0.13
±0.21
±0.50
±1
±2
Max.
60
+70
+85
+105
±0.5
±1.0
±2.5
±1
±16.25
±32.50
±65.0
±2.75
±5.50
±11.00
±25
±50
±100
±0.21
±0.42
±0.83
–
–
Unit
MHz
°C
°C
°C
ppm
ppm
ppm
ppm
ppb
ppb
ppb
ppb
ppb
ppb
ppb/°C
ppb/°C
ppb/°C
ppb/s
ppb/s
ppb/s
ppm
ppm
Initial frequency at 25°C at 48 hours after 2 reflows
[size=14px]Wish you all a happy Chinese New Year! May everything go well! (Prosperity - braised pork; good luck - white-cut chicken; abundance every year - turbot; cleanliness - green vegetables and t...
Preface
This document mainly describes how the TL335x-EVM-S evaluation board controls servo motors based on the EtherCAT master protocol stack of the German Acontis company. The content includes an in...
Today’s highly integrated, configurable power management solutions offer built-in intelligence that greatly simplifies the design process by eliminating the need for external components. This reduces ...
Flow cytometer is a light or impedance based technology used for cell sorting, biomarker detection, protein engineering and diagnosis of health conditions such as blood cancer. Flow cytometer is a com...
The application and development speed of industrial robots
in China's manufacturing industry
ranks first in the world. In 2010,
the density of industrial
robots
in China's manufacturing...[Details]
1. Introduction to LiteOS Huawei's LiteOS provides developers with a "one-stop" complete software platform with key capabilities such as lightweight (kernel less than 10k), low power consumption (o...[Details]
"Stay calm and you will be invincible." We are Tektronix, born for engineers and for solving problems. Beijing, China, December 20, 2019 – At the end of the year, on the afternoon of Dec...[Details]
On March 25, during the first One Earth Summit held in Hong Kong, Zeng Yuqun, chairman and general manager of CATL, revealed in an interview with US media that CATL is working with Tesla to develop...[Details]
On September 3, 2018, Director Li and Deputy Director Zhang of Zhejiang Provincial Foreign Experts Bureau, Director Fan of Huzhou Foreign Experts Bureau, Director Wang of Changxing Coun...[Details]
Tian Jietang, Deputy Director and Researcher of the Innovation and Development Department, Development Research Center of the State Council
Data is a new production factor and the new "oil" th...[Details]
1 Introduction
Touch screens are increasingly used in embedded systems.
The design methods of touch screens in different application fields are also different. Generally, there are three ...[Details]
It’s the golden age of low-power microcontrollers. A half-dozen vendors now offer advanced features in their MCUs to help you save energy in your next microcontroller design. However, mastering all of...[Details]
On January 20, BOE Technology Group Co., Ltd. released its 2021 performance forecast, predicting full-year operating revenue of 215 billion yuan to 220 billion yuan, a year-on-year increase of 59% ...[Details]
The emergence of 5G networks will create tremendous opportunities to build enterprise value across a range of industries and profoundly impact business operations. The report "5G and Its Impact on En...[Details]
1 Introduction to Digital Multimeter Digital measuring instruments have become mainstream because they have high sensitivity, high accuracy, clear display, strong overload capacity, are easy to carry...[Details]
The STC15W408AS MCU integrates 3-way programmable counter array (CCP/PCA) modules that can be used for software timer, external pulse capture, high-speed pulse output and pulse width modulation (PWM)...[Details]
The typical circuit diagram of the SM9000 series integrated voltage regulator module is shown in the figure.
It can be seen from the figure that the application is very convenient. Its internal com...[Details]
Thermistors are generally used as sensors to measure temperature. The measurement methods include R-V conversion voltage measurement method and R-F conversion frequency measurement method. The circu...[Details]
Today's new energy vehicle market is really competitive, not only in terms of price, but also in terms of technology and products. It is said that the second half of the new energy vehicle market i...[Details]