METALLIZED POLYPROPYLENE
TAPE WRAP AND EPOXY FILL CASE
X363
PAGE 4 OF 4
GENERAL SPECIFICATIONS
PHYSICAL CHARACTERISTICS
CONSTRUCTION:
NON-INDUCTIVE WOUND METALLIZED POLYPROPYLENE.
CASE:
FLAME RETARDANT TAPE WRAP CASE AND EPOXY FILL.
LEAD MATERIAL:
AXIAL SOLDER COATED OR TINNED SOLID WIRE, AWG AS SPECIFIED IN TABLES.
DIMENSIONS:
AS SPECIFIED IN TABLES.
ELECTRICAL CHARACTERISTICS
CAPACITANCE:
AS SPECIFIED IN TABLES ± REQUESTED TOLERANCE WHEN MEASURED AT OR
REFERRED TO 1000 ± 20 HZ FOR CAPS GREATER THAN 1.0UF; 120HZ ±20 HZFOR CAP VALUES LESS
THAN OR EQUAL TO 1.0UF AND 25 ± 5 °C.
TOLERANCE:
±1%, ±2%, ±5%, ±10%, AND ±20% AVAILABLE. OTHER TOLERANCES AVAILABLE UPON
REQUEST.
DISSIPATION FACTOR:
SHALL NOT BE GREATER THAN 0.1% WHEN MEASURED AT OR REFERRED TO
1000 ± 20 HZ FOR CAP VALUES GREATER THAN 1.0UF; FOR CAP VALUES LESS THAN OR EQUAL TO
1.0UF AT 120HZ AND 25 ± 5 °C.
INSULATION RESISTANCE:
SHALL BE GREATER THAN 300,000 MΩ FOR CAPACITANCE VALUES 0.33 µF
AND LESS OR 100,000 MΩ X µF FOR CAPACITANCE VALUES GREATER THAN 0.33µF WHEN MEASURED
AFTER 2 MINUTES ELECTRIFICATION AT 100VDC AND 25 ± 5 °C.
DIELECTRIC STRENGTH:
200% RATED VOLTAGE FOR 1 MINUTE THROUGH A LIMITING RESISTANCE
OF 100 OHMS/VOLT AT 25 ± 5 °C.
RATED VOLTAGE:
100VDC, 200VDC, AND 400VDC AVAILABLE.
TEMPERATURE:
-55 °C TO +105 °C AT FULL RATED VOLTAGE OPERATIONAL TEMPERATURE, +105 °C
MAX STORAGE TEMPERATURE.
ADDITIONAL INFORMATION
ORDERING INFORMATION:
ALL ASC CAPACITORS ARE ORDERED BY "FAMILY CAP-TOL-VOLT"
DESIGNATION. (I.E. TO ORDER AN X363 1.0µF, ±10%, 200VDC CAPACITOR, REQUEST PART NUMBER
"X363 1-10-200")
SEE ALSO:
"GENERAL INFORMATION - POLYPROPYLENE CAPACITORS" DOCUMENT FOR ADDITIONAL
PHYSICAL, ELECTRICAL, AND PERFORMANCE CHARACTERISTICS NOT MENTIONED IN THIS FILE.
WARNING:
INFORMATION ON THIS FILE IS SUBJECT TO CHANGE WITHOUT NOTICE AT ASC'S
DISCRETION.
301 WEST O STREET
•
OGALLALA, NE 69153
Phone: (308) 284-3611
Fax: (308) 284-8324
e-mail: sales@ascapacitor.com
web: www.ascapacitor.com