-
1 Introduction
Saturable inductors are inductors with high hysteresis loop rectangular ratio, high initial permeability, low coercive force, and obvious magnetic saturation point. They are...[Details]
-
1. Butterfly calculation
Any DFT with N being an integer power of 2 (i.e. N=2M) can be calculated by M-fold decomposition and finally becoming a 2-point DFT. The M-fold decomposition constitut...[Details]
-
According to reports, in the past 20 years, Amazon has become the company that has applied for the most patents for next-generation car driving technology among the five major U.S. technology giants....[Details]
-
Infineon
Technologies AG (FSE: IFX / OTCQX: IFNNY) has launched a new
automotive power module
,
the HybridPACK
™ Drive G2. The module inherits the proven
HybridPACK
Dr...[Details]
-
Cardiovascular disease is a common disease that endangers human health. Although conventional electrocardiogram diagnosis has high value, when the ECG information is higher than 100Hz, conventional e...[Details]
-
1 Introduction
Today, test engineers spend a significant amount of development time on ADEs. Therefore, the ADE we choose must not only be intuitive and easy to understand, but also support multipl...[Details]
-
Although we are still in the early stages of 5G network deployment, the characteristics and functions of 5G technology have been clarified, and its potential to generate new applications and improve ...[Details]
-
On November 13, according to Taiwan Economic Daily, mature wafer foundry process manufacturers are facing a battle to defend their capacity utilization rate of 60%. It is said that in order to save p...[Details]
-
After many twists and turns, the new kernel finally started the new system. Many thanks to Xiaozu for his guidance, and to the authors of these two articles, who gave me a lot of help. http://blo...[Details]
-
The simulation interface also uses a double-row 2*5 socket, and requires four 10K pull-up resistors.
Important note: In actual application, if you do not want to use JTAG simulation an...[Details]
-
On the morning of December 29th, a new patent from Microsoft revealed the company's prototype of a "multi-panel device" with a tri-fold design. The patent was granted by the U.S. Patent and ...[Details]
-
Regarding dot matrix infrared lamps and traditional LED lamps, we can distinguish them from the following aspects:
1. Brightness: The optical output of a single traditional LED lamp is generally ...[Details]
-
AGV mobile
robot
is a self-driving mobile robot used for material handling and transportation in factories, warehouses, logistics centers and other places. AGV is usually equipped with
...[Details]
-
At least in the previous versions of PCB layout software PADS, I have never seen layer operations. This should be a new addition after PADs9. You must understand these moldless instructions clearly...[Details]
-
Led can be used as a tool for debugging programs: In the early stages of development of embedded system software, such as Bootloader and kernel, since hardware such as serial ports have not yet bee...[Details]
GD32 MCU
京公网安备 11010802033920号
EEWORLD