Features .......................................................................................................................................................................................1
Ordering Information .....................................................................................................................................................................2
Dimensions and Patterns ― 3.2 x 2.5 mm .................................................................................................................................14
Dimensions and Patterns ― 5.0 x 3.2 mm .................................................................................................................................14
Dimensions and Patterns ― 7.0 x 5.0 mm .................................................................................................................................15
Additional Information .................................................................................................................................................................16
Revision History ..........................................................................................................................................................................17
Rev 1.06
Page 3 of 17
www.sitime.com
SiT3373
220 MHz to 725 MHz Ultra-low Jitter Differential VCXO
Electrical Characteristics
Table 2. Electrical Characteristics – Common to LVPECL, LVDS and HCSL
All Min and Max limits in the Electrical Characteristics tables are specified over temperature and rated operating voltage with standard
output termination shown in the termination diagrams. Typical values are at 25°C and nominal supply voltage.
Parameter
Output Frequency Range
Frequency Stability
Symbol
f
F_stab
Min.
220.000001
-15
-25
-35
-50
Operating Temperature Range
T_use
-20
-40
-40
-40
Supply Voltage
Vdd
2.97
2.70
2.52
2.25
Pull Range
Upper Control Voltage
Lower Control Voltage
Control Voltage Input Impedance
Control Voltage Input Bandwidth
Pull Range Linearity
Frequency Change Polarity
Input Voltage High
Input Voltage Low
Input Pull-up Impedance
Duty Cycle
Start-up Time
OE Enable/Disable Time
PR
VC_U
VC_L
VC_z
V_c
Lin
–
VIH
VIL
Z_in
DC
T_start
T_oe
70%
–
–
45
–
–
Typ.
–
–
–
–
–
–
–
–
–
3.30
3.00
2.80
2.50
Max.
725
+15
+25
+35
+50
+70
+85
+95
+105
Supply Voltage
3.63
3.30
3.08
2.75
V
V
V
V
ppm
Vdd
Vdd
MΩ
kHz
%
–
–
30%
-
55
3.0
3.8
Vdd
Vdd
kΩ
%
ms
µs
Measured from the time Vdd reaches its rated minimum value.
f = 322.265625 MHz. Measured from the time OE pin reaches
rated VIH and VIL to the time clock pins reach 90% of swing
and high-Z. See
Figure 9
and
Figure 10
Pin 2, OE
Pin 2, OE
Pin 2, OE logic high or logic low
Contact SiTime
for other input bandwidth options
See the APR (Absolute Pull Range)
Table 11.
Contact SiTime
for custom pull range options
Voltage at which maximum frequency deviation is guaranteed
Voltage at which minimum frequency deviation is guaranteed
Unit
MHz
ppm
ppm
ppm
ppm
°C
°C
°C
°C
Extended Industrial
Extended Commercial
Industrial
Condition
Accurate to 6 decimal places
Inclusive of initial tolerance, operating temperature, rated
power supply voltage, load variations, and first year aging
at 25°C, with VIN voltage at Vdd/2.
±15
ppm is only guaranteed for pull range up to
±100
ppm.
Frequency Range
Frequency Stability
Temperature Range
Voltage Control Characteristics
±25, ±50, ±80, ±100, ±150, ±200,
±400, ±800, ±1600, ±3200
90%
–
–
–
–
–
–
10
10
–
Positive Slope
–
–
100
–
–
–
–
10%
–
–
1.0
Input Characteristics
Output Characteristics
Startup and OE Timing
Rev 1.06
Page 4 of 17
www.sitime.com
SiT3373
220 MHz to 725 MHz Ultra-low Jitter Differential VCXO
Table 3. Electrical Characteristics – LVPECL Specific
Parameter
Current Consumption
OE Disable Supply Current
Output Disable Leakage Current
Maximum Output Current
Output High Voltage
Output Low Voltage
Output Differential Voltage Swing
Rise/Fall Time
RMS Period Jitter
[4]
RMS Phase Jitter (random)
Symbol
Idd
I_OE
I_leak
I_driver
VOH
VOL
V_Swing
Tr, Tf
T_jitt
T_phj
–
0.220
0.270
ps
Min.
–
–
–
–
Vdd-1.15
Vdd-1.9
1.2
–
–
Typ.
–
–
0.15
–
–
–
1.6
225
1.0
Max.
97
63
–
32
Vdd-0.7
Vdd-1.5
2.0
290
1.6
Unit
mA
mA
A
mA
V
V
V
ps
ps
Condition
Excluding Load Termination Current, Vdd = 3.3 V or 2.5 V
OE = Low
OE = Low
Maximum average current drawn from OUT+ or OUT-
See
Figure 5
See
Figure 5
See
Figure 6
20% to 80%, see
Figure 6
f = 322.265625 MHz, Vdd = 3.3 V or 2.5 V
f = 322.265625 MHz, Integration bandwidth = 12 kHz to 20 MHz,
all Vdd levels, includes spurs, pull range =
±100
ppm.
Temperature ranges -20 to 70°C and -40 to 85°C
f = 322.265625 MHz, Integration bandwidth = 12 kHz to 20 MHz,
all Vdd levels, includes spurs, pull range =
±100
ppm.
Temperature ranges -40 to 95°C and -40 to 105°C
f = 156.25 or 322.265625 MHz, IEEE802.3-2005 10 GbE jitter
mask integration bandwidth = 1.875 MHz to 20 MHz,
all Vdd levels
f = 322.265625 MHz, Vdd = 3.3 V or 2.5 V
f = 322.265625 MHz, Integration bandwidth = 12 kHz to 20 MHz,
all Vdd levels, includes spurs, pull range =
±100
ppm.
Temperature ranges -20 to 70°C and -40 to 85°C
f = 322.265625 MHz, Integration bandwidth = 12 kHz to 20 MHz,
all Vdd levels, includes spurs, pull range =
±100
ppm.
Temperature ranges -40 to 95°C and -40 to 105°C
f = 322.265625 MHz, IEEE802.3-2005 10 GbE jitter mask
integration bandwidth = 1.875 MHz to 20 MHz, all Vdd levels
I use the lsm6dsl sensor at 3.3 working voltage, the power consumption will increase by 2mA
Is there something not configured correctly?/*** @briefInitialize the LSM6DSL sensor* @parampObj the device ...
[i=s]This post was last edited by lugl4313820 on 2022-4-4 00:25[/i]My smart cold storage management system first needs to be built: server, wifi, sensor. The current project design is to use RVB to co...
I saw a new evaluation development board on the forum. It is simply a smart watch solution, and it uses Raspberry Pi! Add a battery, a heart rate sensor, and a case, and it becomes a watch.Below is th...
Good news! Good news!Microsoft's new IoT solution, Azure Sphere, is now officially released! This solution combines multiple measures at the hardware, OS, and cloud component levels to proactively pro...
#include msp430.h//MSP430G2553 - Use Timer_A,Up Mode, DCO SMCLK//// Introduction: This program uses the UP mode of TIMER A to generate a 1S square wave on the P1.0 pin.// ACLK = na, SMCLK = MCLK = TAC...
Many students in the college entrance examination today are happy or upset after the Chinese language test. Beijing test questions. The symbols of the capital are not easy to find after more than 3,00...
There are many kinds of single-chip microcomputers, the more common ones are 51 single-chip microcomputers, AVR, MSP430, PIC, STM32, etc. Now I will start with the relatively simple and easy-to-learn ...[Details]
For the single-chip microcomputer, communication is closely integrated with technologies such as sensors, storage chips, and peripheral control chips, becoming the "nerve center" of the entire single...[Details]
On the banks of Suzhou River in Shanghai, the undergrounding, wire removal and pole pulling operations of the overhead lines on Wanhangdu Road are proceeding in an orderly manner. Despite the grand...[Details]
In the previous tweet "NDC simulation function allows AGV vehicles to have a traceable path", we introduced the powerful simulation function of NDC, which can simulate and test the AGV vehicles bef...[Details]
On September 29, Weilan Chuangzao signed a strategic cooperation agreement with the Dongyang Municipal Government, planning to build a Weilan Chuangzao intelligent manufacturing and R&D base in Don...[Details]
In July 2020, the market value of the Science and Technology Innovation Board's unblocked shares reached 191.88 billion, which is 50.5% of the circulating market value of 378.9 billion. The Science a...[Details]
The I/O port cannot output normally because the port is reused. In addition to checking whether there is a program to reuse the port in the program, you should also pay attention to the following: so...[Details]
According to Reuters, a member of Romania's Information Technology and Communications and National Security Committee mentioned that Romania's centrist government approved a U.S.-backed bill on Thurs...[Details]
1 Introduction
Wheeled mobile robot is an important part of the robot research field. It integrates mechanics, electronics, detection technology and intelligent control. Among various mobile m...[Details]
Multimeters are mainly divided into pointer multimeters and digital multimeters. Currently, pointer multimeters are rarely used. Next, we will introduce the use of digital multimeters. Digital mult...[Details]
CP15 — the system control coprocessor. It provides specific registers to configure and control caches, MMU, protection system, and clock mode (used in bootloader clock initialization) through coproces...[Details]
What is the use of hifi amplifier
HiFi amplifier is a power amplifier used in high-fidelity audio systems. It has the following important uses in audio systems:
1. Audio amplification: Th...[Details]
introduction
For robot control technology, real-time and stability are the key points of research. At present, the main method of robot control is to plan the gait in an offline state and ...[Details]
Recently, the National Development and Reform Commission, the Ministry of Science and Technology, the Ministry of Industry and Information Technology, the Ministry of Finance and other four departmen...[Details]
Two-day industry-renowned conference will provide in-depth expertise and skills in the IoT industry
Beijing, China – November 8, 2024 –
Silicon Labs, a global leader in secure, i...[Details]
MEMS sensors
京公网安备 11010802033920号
EEWORLD
