Features ....................................................................................................................................................................................... 1
Ordering Information .................................................................................................................................................................... 2
LVPECL and FlexSwing Termination .................................................................................................................................. 17
LVDS, Supply Voltage: 1.8 V
±5%,
2.5 V ±10%, 3.3 V ±10%, 2.25 V to 3.63 V, 1.71 V to 3.63 V ...................................... 18
HCSL, Supply Voltage: 1.8 V
±5%,
2.5 V ±10%, 3.3 V ±10%, 2.25 V to 3.63 V, 1.71 V to 3.63 V ...................................... 18
Low-power HCSL, Supply Voltage: 1.8 V
±5%,
2.5 V ±10%, 3.3 V ±10%, 2.25 V to 3.63 V, 1.71 V to 3.63 V.................... 18
Dimensions and Patterns ― 2.0 x 1.6 mm x mm ....................................................................................................................... 19
Dimensions and Patterns ― 2.5 x 2.0 mm x mm ....................................................................................................................... 20
Dimensions and Patterns ― 3.2 x 2.0 mm x mm ....................................................................................................................... 21
Revision History ......................................................................................................................................................................... 22
Rev 0.52
Page 3 of 23
www.sitime.com
SiT9375
Low Jitter Differential XO for Standard Frequencies
Electrical Characteristics
ADVANCED
All Min and Max limits in the Electrical Characteristics tables are specified over operating temperature and rated operating
voltage with standard output termination shown in the termination diagrams. Typical values are at 25°C and nominal
supply voltage.
Table 3. Electrical Characteristics – Common to All Output Signaling Types
Parameter
Output Frequency Range
Frequency Stability
Symbol
f
F_stab
–
Min.
Typ.
Max.
Unit
MHz
ppm
Condition
Refer to frequencies listed in
Ordering Information
section.
Inclusive of initial tolerance, operating temperature, rated power
supply voltage, load variation of 15 pF
±
10%, and 10 years
aging at 25°C
Inclusive of initial tolerance, operating temperature, rated power
supply voltage, load variation of 15 pF
±
10%, and first year aging
at 25°C
Ambient temperature of 25°C
Extended commercial, ambient temperature
Industrial, ambient temperature
Ambient temperature
Extended industrial, ambient temperature
Voltage-supply order code “YY”
Voltage-supply order code “XX”
Voltage-supply order code “18”.
Contact SiTime
for 1.5 V
Voltage-supply order code “25”
Voltage-supply order code “33”
Pins 1 and 2 for OE and SE, respectively
Pins 1 and 2 for OE and SE, respectively
Pins 1 and 2 for OE and SE, respectively
See
Figure 5
and
Figure 7
Measured from the time Vdd reaches its rated minimum value
Measured from the time OE pin toggles to enable logic level to
the time clock pins reach 90% of swing. See
Figure 12
Measured from the time OE pin toggles to disable logic level to
the last clock edge. See
Figure 13
12 kHz to 20 MHz offset frequency integration bandwidth,
156.25 MHz
12 kHz to 20 MHz offset frequency range, 156.25 MHz
12 kHz to 20 MHz offset frequency range, 155.52 MHz
156.25 MHz
156.25 MHz
Frequency Range
Standard frequencies
–
±20
Frequency Stability
–
–
–
10 Year Aging
Operating Temperature Range
F_10y
T_use
–
-20
-40
-40
-40
Supply Voltage
Vdd
1.71
2.25
1.71
2.25
2.97
Input Voltage High
Input Voltage Low
Input Pull-up Impedance
Duty Cycle
Startup Time
Output Enable Time
Output Disable Time
VIH
VIL
Z_in
DC
T_start
T_oe
T_od
70%
–
–
45
–
–
–
–
–
–
±1
–
–
–
–
–
–
1.80
2.50
3.30
–
–
100
–
1
–
–
±25
±30
±50
–
+70
+85
+95
+105
ppm
ppm
ppm
ppm
°C
°C
°C
°C
V
V
V
V
V
Temperature Range
Supply Voltage
3.63
3.63
1.89
2.75
3.63
Input Characteristics
–
Vdd
30%
–
55
5
100+3 clock
cycles
100+3 clock
cycles
Vdd
kΩ
%
ms
ns
ns
Output Characteristics
Startup, OE and SE Timing
Jitter and Phase Noise
RMS Phase Jitter (random)
Spurious Phase Noise
RMS Period
Jitter
[1]
Jitter
[1]
T_phj
PN_spur_a
PN_spur_b
T_jitt_per
T_jitt_cc
Peak Cycle-to-cycle
–
–
–
–
–
200
-110
-80
1
6
–
–
–
–
–
fs
dBc
dBc
ps
ps
Note:
1. Measured according to JESD65B.
Rev 0.52
Page 4 of 23
www.sitime.com
SiT9375
Low Jitter Differential XO for Standard Frequencies
ADVANCED
Table 4. Electrical Characteristics – LVPECL
|
Supply voltages: 2.5 V
±10%,
3.3 V
±10%,
2.25 V to 3.63 V
Parameter
Current Consumption, Output
Enabled without Termination
Current Consumption, Output
Enabled with Termination 1
Current Consumption, Output
Enabled with Termination 2
Current Consumption, Output
Disabled without Termination
Current Consumption Output
Disabled with Termination 1
Current Consumption, Output
Disabled with Termination 2
OE Leakage Current
Symbol
Idd_oe_nt
Idd_oe_wt1
Idd_oe_wt2
Idd_od_nt
Idd_od_wt1
Idd_od_wt2
I_leak
Min.
–
–
–
–
–
–
–
Typ.
43
52
71
58
58
86
37
Max.
–
–
–
–
–
–
–
Unit
mA
mA
mA
mA
mA
mA
mA
Condition
Excluding load termination current
Including load termination current. See
Figure 15
for
termination
Including load termination current. See
Figure 18
for
termination
Excluding load termination current
Including load termination current. See
Figure 15
for
termination
Including load termination current. See
Figure 18
for
termination
OE = disable logic, DC termination, OUTP and OUTN held
[i=s]This post was last edited by donatello1996 on 2022-11-3 14:06[/i][Image Recognition ClassificationMotion DetectionAnalog Signal Processing System Based on Raspberry Pi 400, Part 5] Project Summar...
Embedded real-time operating systems provide common queue and semaphore mechanisms for task interaction, and FreeRTOS is no exception. Developers who are new to FreeRTOS usually choose these two famil...
[i=s]This post was last edited by jinglixixi on 2022-3-24 18:17[/i]Recently, Arteli launched a new product AT32F425, which gradually enriched the functions of the AT32F4 series. The appearance of the ...
Scientists in South Korea have made a breakthrough in battery research that could help overcome a key bottleneck in energy storage. The latest research overcomes an important technical challenge in t...[Details]
Using a single chip microcomputer to realize a very simple temperature measurement circuit
The application of single-chip microcomputer in electronic products has become more and more extensiv...[Details]
Foxconn's last remaining channel system, Fulian Network, will be transferred to its subsidiary Sharp for operation. After the exclusive report by "Core Technology", it attracted outside attention. In...[Details]
1. Resistance
When AC current flows through a conductor, the resistance it encounters is called impedance, which is represented by Z and its unit is Ω.
The resistance at this time is ...[Details]
Sustainable development concerns the common future of mankind, and technology is the only way to achieve sustainable development. Recently, Bian Chenggang, Vice President of Intel Manufacturing and S...[Details]
Today, blogger @数码闲聊站 exposed the tempered glass film of Xiaomi 12. @Digital Chat Station revealed that Xiaomi 12 has a dual-curved, hole-punch screen. The camera on the front is centered and...[Details]
Abstract: The new single bus digital temperature and humidity sensor DHTll has the characteristics of small size, simple interface, fast response speed, and high cost performance. This article brie...[Details]
introduction
UPS
power supply system is an essential power supply for power, communication, banking and other industries. It has a history of several decades since its creation....[Details]
1. Increasing server density By the end of 2020, the digital universe (a measure of all digital data created, copied, and consumed in a year) will reach 40 zettabytes (40×1024 bytes), a 50-fo...[Details]
"Tell me, why should I buy your SPARQ instead of VNA?" If you ask me this, I'm sorry, maybe I will ask you in return, what is your real test demand? What I want to say is that SPARQ is the best S para...[Details]
Although Mi 7 is still very mysterious, the information of Xiaomi Mi MIX 2S has gradually surfaced. It is rumored that it is expected to be launched during the MWC exhibition which will open on Feb...[Details]
It is mainly divided into three parts: (1) 51 single-chip microcomputer program part; (2) Keil tool part; (3) Why printf outputs to the serial port. (1) 51 MCU program part #include stdio.h #inc...[Details]
first day What resources are available? 1. An MPU6050 2. A stm32f103rc minimum system version with ucos3 ported to it, running several tasks, including an LCD task (lowest priority) 3.st firmware lib...[Details]
Introduction: With the rapid development of microelectronics technology, digital-to-analog converters (DACs) are playing an increasingly important role as a bridge between the digital world and analo...[Details]
As we all know, all vehicles equipped with engines must meet the National VI emission regulations. Starting from the "Light Vehicle Pollutants and Measurement Methods (China Phase VI)" issued on De...[Details]
Suggestions & Announcements
京公网安备 11010802033920号
EEWORLD
