Features .......................................................................................................................................................................................1
Ordering Information .....................................................................................................................................................................2
Dimensions and Patterns ― 3.2 x 2.5 mm .................................................................................................................................14
Dimensions and Patterns ― 5.0 x 3.2 mm .................................................................................................................................14
Dimensions and Patterns ― 7.0 x 5.0 mm .................................................................................................................................15
Additional Information .................................................................................................................................................................16
Revision History ..........................................................................................................................................................................17
Rev 1.07
Page 3 of 17
www.sitime.com
SiT3373
220 MHz to 725 MHz Ultra-low Jitter Differential VCXO
Electrical Characteristics
Table 2. Electrical Characteristics – Common to LVPECL, LVDS and HCSL
All Min and Max limits in the Electrical Characteristics tables are specified over temperature and rated operating voltage with standard
output termination shown in the termination diagrams. Typical values are at 25°C and nominal supply voltage.
Parameter
Output Frequency Range
Frequency Stability
Symbol
f
F_stab
Min.
220.000001
-15
-25
-35
-50
Operating Temperature Range
T_use
-20
-40
-40
-40
Supply Voltage
Vdd
2.97
2.70
2.52
2.25
Pull Range
Upper Control Voltage
Lower Control Voltage
Control Voltage Input Impedance
Control Voltage Input Bandwidth
Pull Range Linearity
Frequency Change Polarity
Input Voltage High
Input Voltage Low
Input Pull-up Impedance
Duty Cycle
Start-up Time
OE Enable/Disable Time
PR
VC_U
VC_L
VC_z
V_c
Lin
–
VIH
VIL
Z_in
DC
T_start
T_oe
70%
–
–
45
–
–
Typ.
–
–
–
–
–
–
–
–
–
3.30
3.00
2.80
2.50
Max.
725
+15
+25
+35
+50
+70
+85
+95
+105
Supply Voltage
3.63
3.30
3.08
2.75
V
V
V
V
ppm
Vdd
Vdd
MΩ
kHz
%
–
–
30%
-
55
3.0
3.8
Vdd
Vdd
kΩ
%
ms
µs
Measured from the time Vdd reaches its rated minimum value.
f = 322.265625 MHz. Measured from the time OE pin reaches
rated VIH and VIL to the time clock pins reach 90% of swing
and high-Z. See
Figure 9
and
Figure 10
Pin 2, OE
Pin 2, OE
Pin 2, OE logic high or logic low
Contact SiTime
for other input bandwidth options
See the APR (Absolute Pull Range)
Table 11.
Contact SiTime
for custom pull range options
Voltage at which maximum frequency deviation is guaranteed
Voltage at which minimum frequency deviation is guaranteed
Unit
MHz
ppm
ppm
ppm
ppm
°C
°C
°C
°C
Extended Industrial
Extended Commercial
Industrial
Condition
Accurate to 6 decimal places
Inclusive of initial tolerance, operating temperature, rated
power supply voltage, load variations, and first year aging
at 25°C, with VIN voltage at Vdd/2.
±15
ppm is only guaranteed for pull range up to
±100
ppm.
Frequency Range
Frequency Stability
Temperature Range
Voltage Control Characteristics
±25, ±50, ±80, ±100, ±150, ±200,
±400, ±800, ±1600, ±3200
90%
–
–
–
–
–
–
10
10
–
Positive Slope
–
–
100
–
–
–
–
10%
–
–
1.0
Input Characteristics
Output Characteristics
Startup and OE Timing
Rev 1.07
Page 4 of 17
www.sitime.com
SiT3373
220 MHz to 725 MHz Ultra-low Jitter Differential VCXO
Table 3. Electrical Characteristics – LVPECL Specific
Parameter
Current Consumption
OE Disable Supply Current
Output Disable Leakage Current
Maximum Output Current
Output High Voltage
Output Low Voltage
Output Differential Voltage Swing
Rise/Fall Time
RMS Period Jitter
[4]
RMS Phase Jitter (random)
Symbol
Idd
I_OE
I_leak
I_driver
VOH
VOL
V_Swing
Tr, Tf
T_jitt
T_phj
–
0.220
0.270
ps
Min.
–
–
–
–
Vdd-1.15
Vdd-1.9
1.2
–
–
Typ.
–
–
0.15
–
–
–
1.6
225
1.0
Max.
97
63
–
32
Vdd-0.7
Vdd-1.5
2.0
290
1.6
Unit
mA
mA
A
mA
V
V
V
ps
ps
Condition
Excluding Load Termination Current, Vdd = 3.3 V or 2.5 V
OE = Low
OE = Low
Maximum average current drawn from OUT+ or OUT-
See
Figure 5
See
Figure 5
See
Figure 6
20% to 80%, see
Figure 6
f = 322.265625 MHz, Vdd = 3.3 V or 2.5 V
f = 322.265625 MHz, Integration bandwidth = 12 kHz to 20 MHz,
all Vdd levels, includes spurs, pull range =
±100
ppm.
Temperature ranges -20 to 70°C and -40 to 85°C
f = 322.265625 MHz, Integration bandwidth = 12 kHz to 20 MHz,
all Vdd levels, includes spurs, pull range =
±100
ppm.
Temperature ranges -40 to 95°C and -40 to 105°C
f = 156.25 or 322.265625 MHz, IEEE802.3-2005 10 GbE jitter
mask integration bandwidth = 1.875 MHz to 20 MHz,
all Vdd levels
f = 322.265625 MHz, Vdd = 3.3 V or 2.5 V
f = 322.265625 MHz, Integration bandwidth = 12 kHz to 20 MHz,
all Vdd levels, includes spurs, pull range =
±100
ppm.
Temperature ranges -20 to 70°C and -40 to 85°C
f = 322.265625 MHz, Integration bandwidth = 12 kHz to 20 MHz,
all Vdd levels, includes spurs, pull range =
±100
ppm.
Temperature ranges -40 to 95°C and -40 to 105°C
f = 322.265625 MHz, IEEE802.3-2005 10 GbE jitter mask
integration bandwidth = 1.875 MHz to 20 MHz, all Vdd levels
The design is relatively simple. The mobile phone is connected to the microcontroller via UART. The PWM can adjust the speed arbitrarily. Pay attention to the driving voltage of the fan.#include msp43...
There is no specific circuit mentioned, but I just studied the parameters of the diode and found that the power dissipation parameter seems to be around 1W. Assuming a reverse connection protection ci...
2019 Intel FPGA Engineer Application Video! The content mainly focuses on the troubles of FPGA engineers, and teaches everyone how to solve some common problems and imparts tips.Let’s take a look at w...
When the AD PCB is enlarged, there are many white lines, not flying lines, and many horizontal bars. If it is not enlarged, there are only flying lines. Please help, what is going on?...
In addition, in order to meet the needs of actual production and power saving, LEDs usually need to be dimmed. The implementation of dimming circuits not only saves energy and reduces waste, but also...[Details]
In recent years, low dropout regulators (LDO) have been widely used in various
electronic
devices, especially consumer electronics with stringent requirements for power. However, with th...[Details]
The kind of emulator you mentioned can completely replace the single-chip microcomputer, which should be the earliest emulation technology used in the past. At this time, the emulator is actually a si...[Details]
On January 11, we learned from the official that Honda Giken Industrial (China) Investment Co., Ltd. and Dongfeng Motor Group Co., Ltd. will cooperate to start technical verification of Honda’s fuel ...[Details]
Solar energy is getting closer and closer to ordinary consumers. In addition to solar water heaters, solar landscape lights, solar roofs, solar mobile phones, solar street lights and other applicatio...[Details]
How far away does the EMI radiation source need to be in order for the radiation signal to not interfere with the system? To know the answer, let us first start with a deeper understanding of the rad...[Details]
The LTM4620 is a complete dual-channel 13A output switch mode DC/DC power supply. The switch controller, power FETs, inductor and all supporting components are built into the package. The LTM4620 c...[Details]
ams and Ibeo have announced that their collaboration to bring solid-state LiDAR technology for autonomous driving to market has made significant progress. ams and Ibeo began jointly developing the ib...[Details]
According to Reuters, Huawei's rotating chairman Xu Zhijun said that in the future Huawei will build millimeter-wave radar based on 5G technology and develop lidar to solve the cost and performan...[Details]
On April 25, on the eve of the opening of the Beijing International Auto Show, NavInfo officially released the NI in Car integrated automotive intelligence solution, which comprehensively covers mu...[Details]
On October 23, 2021, Silicon Micro released the millimeter wave sensor life presence sensing reference design XenD101Pro. With the highly integrated, low-power, and small-volume
millimeter wave...[Details]
The so-called withstand voltage tester can be called an electrical insulation strength tester, a dielectric strength tester, etc. according to its function. Its working principle is: a voltage high...[Details]
On June 30, the groundbreaking ceremony for the flexible optical film manufacturing project of Anhui Film Materials Co., Ltd. was held in Yingshang, Anhui. It is reported that Anhui Filmu Materials...[Details]
Servo presses and ordinary presses are two different types of presses. There are many differences between them in working principle, structure, performance, application, etc.
introduction...[Details]
Microcontroller MCU
京公网安备 11010802033920号
EEWORLD
