Note: A 0.01 Ohm addition to be added to the performance of all resistors <10 Ohms.
Pulse Performance Data
Lightning Surge
Lightning surge resistors are tested in accordance with IEC 60 115-1 using both 1.2/50µs and 10/700µs pulse shapes. 10 pulses are applied. The limit of
acceptance is a shift in resistance of less than 1% from the initial value.
2512
2010
1206
0805
0603
2512
2010
1206
0805
0603
General Note
TT Electronics reserves the right to make changes in product specification without notice or liability.
All information is subject to TT Electronics’ own data and is considered accurate at time of going to print.
The single impulse graph is the result of 50 impulses of rectangular shape applied at one minute intervals. The limit of acceptance was a shift in
resistance of less than 1% from the initial value.
2512
2010
1206
0805
0603
Continuous Load Due to Repetitive Pulses
The continuous load graph was obtained by applying repetitive rectangular pulses where the pulse period was adjusted so that the average
power dissipated in the resistor was equal to its rated power at 70°C. Again the limit of acceptance was a shift in resistance of less than 1% from the
initial value
2512
2010
1206
0805
0603
General Note
TT Electronics reserves the right to make changes in product specification without notice or liability.
All information is subject to TT Electronics’ own data and is considered accurate at time of going to print.
This is a push-pull switching power supply made by Saber that I referred to. It uses the SG3824 PWM chip. I cannot get the waveform by connecting according to the datasheet. I would like to ask for yo...
[i=s]This post was last edited by zhang1gong on 2022-4-24 21:59[/i]The title cannot accommodate more words, rewrite the title:
The results of cross-compiling Tina Linux system under several different ...
IntroductionThe optimization control of the position of the solar panel is achieved by real-time collection of the output voltage of the solar panel, which is controlled by a single-chip microcomputer...
I am working on a project that requires low power consumption. The chip I am using is STM32F103C8T6. I modified the program like this:Stm32_Clock_Init(2); The crystal oscillator is 8M, double the freq...
New hot spots in automobiles: TI's star products in T-BOX (in progress)InterfacePHYSection 1 DP83TC811S-Q1: Automotive Ethernet makes your T-BOX even more powerfulCANStay tuned………New hotspot in automo...
FPGA/CPLD
京公网安备 11010802033920号
EEWORLD
