-
The lighting of LED lights, digital tubes, and buttons introduced earlier only use the IO resources of the 51 microcontroller. If we only use the microcontroller to light up lights and operate digita...[Details]
-
Abstract: This paper focuses on the design of a new display system based on ETX module, which mainly includes the digital conversion of analog video signals and the design of LVDS video bus. The pa...[Details]
-
This is an ultrasonic distance measurement module program I wrote a few days ago. The ultrasonic distance measurement module uses HC-SR04 and the microcontroller is STC80C52RC. However, I bought a mi...[Details]
-
1. All GPIOs of STM32 can be used as input terminals of external interrupt sources to capture external signals. They can be configured as falling edge interrupt, rising edge interrupt and rising and ...[Details]
-
introduction
Setting the reset flag bit is convenient for distinguishing resets caused by different reasons. As a new technology, it is adopted by more and more new microcontrollers. For example,...[Details]
-
1 Introduction
Modern electronic information equipment often needs to store and process a large amount of digital information. A high-performance memory controller can greatly improve the perform...[Details]
-
At present, the smoothing of power peak-valley differences, the safety, reliability and power quality of the power grid, the development of renewable energy and the development of smart grid technolo...[Details]
-
According to the latest news from foreign media, new documents from the Nintendo Switch FCC indicate that Nintendo plans to update the Switch's SoC and RAM. Earlier this week, reports surfaced of a...[Details]
-
source code: void RTC_Display(void) { U16 year ; U8 month, day ; // week U8 hour, minute, second ; RTC_Time_Set() ; Note: Initial date and time settings Uart_Printf( "\nRTC TIME Display, pre...[Details]
-
#include reg51.h #define uint unsigned int uint DIDA=0,SEC=0,MIN=0,HOUR=0,h=0; code char tab ={0x3f,0x06,0x5b,0x4f,0x66,0x6d,0x7d,0x07,0x7f,0x6f}; void timer0() interrupt 1 using 1 ...[Details]
-
1 Introduction
LED is a type of light-emitting device that can directly convert electrical energy into visible light and radiation energy. It has a series of characteristics such as low operating...[Details]
-
In the circuit diagram of the tail board of the OM8373 super chip color TV, there is often a shutdown bright spot elimination circuit composed of CY07 (100μF), VDY09 (1N4148), VY10 (2SC1815), etc.,...[Details]
-
On November 5, the 2023 Industrial Software Ecology Conference co-sponsored by the Guangdong Provincial Department of Industry and Information Technology, Guangdong Provincial Department of Science a...[Details]
-
(Image source: XALT official website) According to foreign media reports, XALT Energy has launched a low-profile, high-energy-density commercial vehicle battery pack. The battery pack uses new pow...[Details]
-
Ideal L8 has two versions, pro and max. The pro version is based on the Horizon Journey J5
intelligent driving
system, while the max version is based on
NVIDIA
Orin.
Du...[Details]