The properly and electrostatically measured taping materials are used for the components, but attention should be paid to the fact that there is some danger the parts absorb on the top
tapes to cause a failure in the mounting and the parts are destructed by static electricity (more than 1kV : 1J, 2A, 2B, 2E 0.5kV : 1E, Human Body Model 100pF 1.5kΩ) to change the
resistance in the conditions of an excessive dryness or after the parts are given vibration for a long time as they are packaged on the tapes. Similarly, care should be given not to apply the
excessive static electricity when mounting on the boards.
●
Ionic impurities such as flux etc. that are attached to these products or those mounted onto a PCB, negatively affect their moisture resistance, corrosion resistance, etc. The flux may
contain ionic substances like chlorine, acid, etc. while perspiration and saliva include ionic impurities like sodium (Na
＋
), chrorine (Cl
−
) etc. Therefore these kinds of ionic substances may
induce electrical corrosion when they invade into the products. Either thorough washing or using RMA solder and flux are necessary since lead free solder contains ionic substances.
Washing process is needed, before putting on moisture proof material in order to prevent electrical corrosion.
●
Please pay attention that the top of an iron does not direct touch to the components. There is a risk that may cause a change in resistance. Take care that another risk may happen that
the protecting coat is carbonized in an instant when touched directly by the top of the iron, also climatic-proof for electric corrosion or insulation of protecting coat may be dropped down.
Be sure not to give high temperature on the top of the iron as it will degrade the protecting coat.
●
Avoid storing components under direct sun rays, high temperature/humidity. Direct sun rays will cause quality change of taping and difficulty of keeping appropriate peeling strength. 5∼
35℃/35∼75%RH, there is no deterioration of solderability for 12 months, but take special care for storing, because condensation, dust, and toxic gas like hydrogen sulfide, sulfurous acid
gas, hydrogen chloride, etc. may drop solderability.
I would like to ask how to use the IS pin of BTS7960. I am confused after reading the manual. Is it possible to read the value directly by connecting a resistor in series with the ADC pin of the micro...
Hongmeng Development Board Neptune ( Part 2 ) —— Development Environment
After I received the Neptune development board, I immediately started setting up the development environment. I was in a hurry ...
1. Enable the device EMIFA module2. Configure the CEnCFG register3. Initialize the EMIFA module4. Open the EMIFA module5. Set the parameters configured in 2 to the opened EMIFA moduleComplete configur...
[i=s]This post was last edited by btty038 on 2020-6-9 23:33[/i]All devices connected to the mobile Internet require RF front-end chips. As the number of connected devices continues to increase, the RF...
As a student majoring in electronics, I am average in professional courses. I can understand analog and digital electronics in class but cannot solve problems. Now I am working, and I feel that I lack...
Base stations have long been integrated into our lives, just like water and electricity, serving us all the time. However, this behind-the-scenes hero is not understood by most people.
After reading t...
Motor Drive Control（Motor Control）
京公网安备 11010802033920号
EEWORLD
