Features ....................................................................................................................................................................................... 1
Ordering Information .................................................................................................................................................................... 2
LVPECL and FlexSwing Termination .................................................................................................................................. 17
LVDS, Supply Voltage: 1.8 V
±5%,
2.5 V ±10%, 3.3 V ±10%, 2.25 V to 3.63 V, 1.71 V to 3.63 V ...................................... 18
HCSL, Supply Voltage: 1.8 V
±5%,
2.5 V ±10%, 3.3 V ±10%, 2.25 V to 3.63 V, 1.71 V to 3.63 V ...................................... 18
Low-power HCSL, Supply Voltage: 1.8 V
±5%,
2.5 V ±10%, 3.3 V ±10%, 2.25 V to 3.63 V, 1.71 V to 3.63 V.................... 18
Dimensions and Patterns ― 2.0 x 1.6 mm x mm ....................................................................................................................... 19
Dimensions and Patterns ― 2.5 x 2.0 mm x mm ....................................................................................................................... 20
Dimensions and Patterns ― 3.2 x 2.0 mm x mm ....................................................................................................................... 21
Revision History ......................................................................................................................................................................... 22
Rev 0.52
Page 3 of 23
www.sitime.com
SiT9375
Low Jitter Differential XO for Standard Frequencies
Electrical Characteristics
ADVANCED
All Min and Max limits in the Electrical Characteristics tables are specified over operating temperature and rated operating
voltage with standard output termination shown in the termination diagrams. Typical values are at 25°C and nominal
supply voltage.
Table 3. Electrical Characteristics – Common to All Output Signaling Types
Parameter
Output Frequency Range
Frequency Stability
Symbol
f
F_stab
–
Min.
Typ.
Max.
Unit
MHz
ppm
Condition
Refer to frequencies listed in
Ordering Information
section.
Inclusive of initial tolerance, operating temperature, rated power
supply voltage, load variation of 15 pF
±
10%, and 10 years
aging at 25°C
Inclusive of initial tolerance, operating temperature, rated power
supply voltage, load variation of 15 pF
±
10%, and first year aging
at 25°C
Ambient temperature of 25°C
Extended commercial, ambient temperature
Industrial, ambient temperature
Ambient temperature
Extended industrial, ambient temperature
Voltage-supply order code “YY”
Voltage-supply order code “XX”
Voltage-supply order code “18”.
Contact SiTime
for 1.5 V
Voltage-supply order code “25”
Voltage-supply order code “33”
Pins 1 and 2 for OE and SE, respectively
Pins 1 and 2 for OE and SE, respectively
Pins 1 and 2 for OE and SE, respectively
See
Figure 5
and
Figure 7
Measured from the time Vdd reaches its rated minimum value
Measured from the time OE pin toggles to enable logic level to
the time clock pins reach 90% of swing. See
Figure 12
Measured from the time OE pin toggles to disable logic level to
the last clock edge. See
Figure 13
12 kHz to 20 MHz offset frequency integration bandwidth,
156.25 MHz
12 kHz to 20 MHz offset frequency range, 156.25 MHz
12 kHz to 20 MHz offset frequency range, 155.52 MHz
156.25 MHz
156.25 MHz
Frequency Range
Standard frequencies
–
±20
Frequency Stability
–
–
–
10 Year Aging
Operating Temperature Range
F_10y
T_use
–
-20
-40
-40
-40
Supply Voltage
Vdd
1.71
2.25
1.71
2.25
2.97
Input Voltage High
Input Voltage Low
Input Pull-up Impedance
Duty Cycle
Startup Time
Output Enable Time
Output Disable Time
VIH
VIL
Z_in
DC
T_start
T_oe
T_od
70%
–
–
45
–
–
–
–
–
–
±1
–
–
–
–
–
–
1.80
2.50
3.30
–
–
100
–
1
–
–
±25
±30
±50
–
+70
+85
+95
+105
ppm
ppm
ppm
ppm
°C
°C
°C
°C
V
V
V
V
V
Temperature Range
Supply Voltage
3.63
3.63
1.89
2.75
3.63
Input Characteristics
–
Vdd
30%
–
55
5
100+3 clock
cycles
100+3 clock
cycles
Vdd
kΩ
%
ms
ns
ns
Output Characteristics
Startup, OE and SE Timing
Jitter and Phase Noise
RMS Phase Jitter (random)
Spurious Phase Noise
RMS Period
Jitter
[1]
Jitter
[1]
T_phj
PN_spur_a
PN_spur_b
T_jitt_per
T_jitt_cc
Peak Cycle-to-cycle
–
–
–
–
–
200
-110
-80
1
6
–
–
–
–
–
fs
dBc
dBc
ps
ps
Note:
1. Measured according to JESD65B.
Rev 0.52
Page 4 of 23
www.sitime.com
SiT9375
Low Jitter Differential XO for Standard Frequencies
ADVANCED
Table 4. Electrical Characteristics – LVPECL
|
Supply voltages: 2.5 V
±10%,
3.3 V
±10%,
2.25 V to 3.63 V
Parameter
Current Consumption, Output
Enabled without Termination
Current Consumption, Output
Enabled with Termination 1
Current Consumption, Output
Enabled with Termination 2
Current Consumption, Output
Disabled without Termination
Current Consumption Output
Disabled with Termination 1
Current Consumption, Output
Disabled with Termination 2
OE Leakage Current
Symbol
Idd_oe_nt
Idd_oe_wt1
Idd_oe_wt2
Idd_od_nt
Idd_od_wt1
Idd_od_wt2
I_leak
Min.
–
–
–
–
–
–
–
Typ.
43
52
71
58
58
86
37
Max.
–
–
–
–
–
–
–
Unit
mA
mA
mA
mA
mA
mA
mA
Condition
Excluding load termination current
Including load termination current. See
Figure 15
for
termination
Including load termination current. See
Figure 18
for
termination
Excluding load termination current
Including load termination current. See
Figure 15
for
termination
Including load termination current. See
Figure 18
for
termination
OE = disable logic, DC termination, OUTP and OUTN held
Participants who obtain LSM6DSOX+STEVAL-MKI109V3 can get started faster by following the information below:1. Official LSM6DSOX state machine (FSM) and machine learning (MLC) function database
Click h...
Applicable to EM35XX and EFR32 platforms.Low-power devices are divided into several modes. In normal development, the EM2 mode of sleep is generally selected, so here we will mainly talk about the pro...
SPI is a high-speed, full-duplex, synchronous communication bus, and only occupies four wires on the chip pins, saving the chip pins and saving space on the PCB layout, providing convenience. It is ma...
This article introduces the use of table components in Qt, which requires the use of QTableWidget.
Let's introduce QTableWidget through an example. The following figure shows the test effect of the ta...
The company's recent project is using RL78 and G14, and it will be mass-produced soon. I haven't found a suitable burner. I saw a company on Taobao that day and bought one. I tried it and it works ver...
Download source package:
https://www.embedthis.com/esp/download.html
The version I downloaded is : esp-8.0.3-src.tgz
Unzip:
$ cd
$ tar xf esp-8.0.3-src.tgz
$ cd esp-8.0.3/Source cross-compilation tool...
The latest forecast from market research firm Canalys shows that the economic recession caused by the epidemic will lead to a sharp decline in PC and tablet sales in 2020. Image source: Canalys off...[Details]
"Based on the experience of fuel cell research and development, solid-state batteries still need to be developed step by step. First, the electrolyte problem, then the negative electrode problem, a...[Details]
#include stdio.h
class TuiLi //Inference class
{
//Private method part
protected:
SYSTEMTIME TIME; //Standard system time storage structure with 8 members and 16 bytes
struct FZ
{
int y...[Details]
In 2018, domestic brand industrial robots accounted for 32.2% of the domestic market, with sales increasing by 16.2% year-on-year; sales of foreign brand industrial robots in China fell by 10.98% yea...[Details]
Higher current carrying capacity and higher power
Rated insulation voltage 1500V
Maximum heating current up to 63A
Comprehensive coverage of high-power string inverters.
...[Details]
The lab facilitates in-house testing to help develop next-generation innovations for automotive and power conversion systems
November 21, 2023
-
ON
Semico...[Details]
On October 12, in response to investors' questions on the interactive platform, "What are the projects under construction? How much is the investment?", Zhan Shengwei stated that the company's curren...[Details]
One is to directly mix and embed it in the source program, the second is to make it into a library function call, and the third is to make it into an intermediate file and add it in the link. I...[Details]
1. Basic concepts of IIC bus 1.1 Bus Overview The IIC bus is a serial bus launched by PHLIPS. It is a high-performance serial bus with bus arbitration and high- and low-speed device synchronizati...[Details]
On June 9, Zhejiang Jingrui Electronic Technology Co., Ltd. (hereinafter referred to as "Jingrui Electronic") started up in Lishui Economic Development Zone, Zhejiang Province, and began trial produc...[Details]
Silicon and silicon carbide hybrid solution increases output power by 15% while reducing size
Shanghai, China - August 28, 2024 -
ON Semiconductor has introduced its latest gener...[Details]
After mastering the basic ARM assembly instructions, to write a simple ARM assembly program, you must also master the basic ARM assembly pseudo-operations (directives). Now let's look at a simple asse...[Details]
OFweek Cup · OFweek 2023 China
Robot
Industry Annual Selection (abbreviated as OFweek Robot Awards 2023) is jointly organized by OFweek, China's high-tech industry portal, and its authorita...[Details]
Packaging is more than just the last step in chip manufacturing. As the physical interface between the processor and the motherboard, packaging provides a landing area for the chip's electrical signa...[Details]
During the 2020 China Mobile Global Partner Conference, news leaked that China Mobile, China Unicom, and China Telecom, the three major operators, may jointly announce the commercial use of 5G messag...[Details]
ST MEMS Sensor Creative Design Competition
京公网安备 11010802033920号
EEWORLD
