1. Project Background
Morse code enthusiasts need a Morse code training machine. Professional training machines are boring and tedious, and more importantly, expensive. A training machine costs severa...
Sometimes you will see two 49.9Ω resistors connected across the differential line connected to the RJ45 connector, and a capacitor connected to GND in the middle, and even the other end of the capacit...
[i=s]This post was last edited by lising on 2022-4-11 10:21[/i]This comprehensive experiment uses the GD32L233C-START development board to make a kitchen countdown timer with a timing range of 1 (min)...
The previous articles (starting from i.MX6ULL Embedded Linux Development 1-Preliminary Exploration of Uboot Transplantation ) introduced the system transplantation of embedded Linux (Uboot, kernel and...
Recently I took a look at the information of the lpc824 DIP development board and found that there are two components FB1 and FB2 on the board, which are used to connect AGND and DGND. The schematic s...
The debug script reads out that a register is 1 after power-on. This section of code is generated by a for loop. The initial values of the other registers are normal and there is no problem with the t...