1. DIP switch
This is a cross section of a plain old DIP switch. There are four groups of switches in this component. This is one of the switches.
This is the annotated version. It looks very simple. ...
After a circuit board is soldered, when checking whether the circuit board can work normally, it is usually not powered on directly. Instead, follow the steps below to ensure that there are no problem...
Application scenario: The switch uses MOS 47N60 or IPW60R045CP, and it is best if both can be driven. The driver supply voltage is 12-15V. [/backcolor][/color] [color=rgb(85, 85, 85)][backcolor=rgb(25...
As the demand for switching power supplies continues to grow in many industries, measuring and analyzing the power loss of the next generation of switching power supplies is critical. This article des...
This article and design code were written by FPGA enthusiast Xiao Meige. Without the author's permission, this article is only allowed to be copied and reproduced on online forums, and the original au...
If the microcontroller serial port and the driver module are placed on the same wire and the load is working, it will burn the microcontroller. What is the best communication method for this serial po...