The common GPIO ports used on the development board are 4 LEDs, 1 button, and 3 enable pins U, V, and W. The Hall sensor is not used yet, so it is omitted.
1. Hardware circuit design
(1) Three enable ...
[i=s]This post was last edited by Jacktang on 2020-11-4 07:41[/i]Experimental resultsAfter installing the HC-PDA-ANDROID.apk software on the phone, the system is turned on. The phone can search for th...
When debugging the RL78 microcontroller, a problem was found that a driver IO could not be reset to zero.
But inserting a breakpoint found that it was possible, the solution steps are:Therefore, I sus...