According to "Adding Flash Read and Write to an Existing mmWave Project", the code snippet is as follows:
/* Setup the PINMUX to bring out the QSPI */
Pinmux_Set_OverrideCtrl(SOC_XWR14XX_PINR10_PADAP,...
I am a newbie and I really don't know much about this. Could you please recommend a chip that can boost 3.3V to 5V, preferably one with higher efficiency?...
Yesterday, I tested that SPI NSS could not be pulled low. Today, I debugged step by step and found the reason. The record is as follows:
Originally, the records were based on serial numbers.
*/
/* 结构体...
1 Introduction
I have been engaged in the industry of IoT smart home, and I am quite familiar with Silicon. Their Zigbee is the No.1 in the industry, and I use it a lot in IoT Zigbee. I am very famili...
1. Experimental tasks Use AT89S51 single-chip microcomputer to make a manual counter. Connect a touch switch to the P3.7 pin of the AT89S51 single-chip microcomputer as a manual counting button. Conne...