MEMS RACKMOUNT SINGLE-MODE 1XN SWITCH
CONFIGURABLE UP TO 1x128
DiCon’s MEMS Rackmount Single-mode 1xN Switch allows a
common input fiber to be switched to any one of N output fibers.
Based on DiCon’s industry proven MEMS optical switches, this
system offers reliable switching over a very long lifetime.
FEATURES
n
n
n
n
Proven MEMS durability and reliability
Available in any 1xN size up to 1x128
Lifetime over 1 billion switch cycles
Simple rackmount design
APPLICATIONS
n
n
n
Fiber Monitoring
Fiber Sensing
Test & Measurement
Specifications subject to change. Copyright © 2014 DiCon Fiberoptics, Inc. All rights reserved.
MEMS RACKMOUNT SINGLE-MODE 1XN SWITCH
CONFIGURABLE UP TO 1x128
OPTICAL SPECIFICATIONS
1
PARAMETER
Up to 1x8
Insertion
Loss
2,3
Up to 1x12
RATING
0.8 dB max.
Product
Code
MSR
MEMS
Rackmount
Switch
1xN, Specify N≤128
Type
1U Rackmount
2U Rackmount
4U Rackmount
ORDERING INFORMATION
MSR
9
B
Crosstalk
4
1.2 dB max.
Up to 1x36
1.5 dB max.
Up to 1x56
2.2 dB max.
Up to 1x128
2.4 dB max.
-50 dB max.
-50 dB max.
40
ms max.
0.40 dB max.
0.30 dB max.
0.15 dB max.
0.02 dB max.
10
9
cycles min.
500 mW max.
-5 to 70
o
C
-40 to 85
o
C
9/125
mm
single mode
Switch
Configuration
1xN
Housing
1U
2U
4U
Back Reflection
Switching Time
TDL
WDL
5
PDL
Repeatability
6,7
Durability
Optical
Power
Operating
Temp
Storage Temp
Fiber Type
Control
Interface
ETH
Ethernet
RS2
RS232
Wavelength
Range
13
1290 - 1330
nm
15
1530 - 1570
nm
16
1570 - 1610 nm
13/15
1290 - 1330 & 1530 - 1570 nm
15/16
1530 - 1570 & 1570 - 1610 nm
Fiber Type
9
Or other equivalent 9mm Singlemode fiber
Corning SMF-28
Also Available: SC, SC/UPC, SC/APC, ST, ST/UPC, LC
Port
Type
B
Bulkhead
Adaptors
ELECTRICAL SPECIFICATIONS
PARAMETER
Latching Type
Control Type
Input Voltage
Connector
Ethernet
Type
RS232
RATING
Non-latching
Ethernet or RS232
90 - 264 VAC
RJ45
9 Pin DB9
Port
Location
F
R
Front Panel
Rear
Panel
FRONT PANEL CONNECTOR & CHASSIS OPTIONS
1
CHASSIS SIZE
1U
2U
4U
FC/APC
FC/UPC
1x42
1x72
1x230
SC/APC
SC/UPC
1x54
1x80
1x225
LC/APC
LC/UPS
1x84
1x144
1x380
1. Maximum 1xN size based on connector spacing and chassis size.
DiCon Fiberoptics, Inc. 1689 Regatta Blvd. Richmond, CA 94804 Tel. (510) 620-5000 Fax. (510) 620-4100 www.diconfiberoptics.com
0143D
MEMS RACKMOUNT SINGLE-MODE 1XN SWITCH
1. Specifications are without connectors.
2. IL is for single band. Dual-Band adds 0.2 dB
3. IL is measured at CWL, 23
o
C.
4. Power off isolation is same as crosstalk.
5. WDL is measured in a +/- 20nm range at 23
o
C.
6. Repeatability is defined after 100 cycles.
7. Add 0.02 dB for switches with more than 12 channels.
Connector
Type
FC/SPC FC/SPC
FC/APC FC/APC
MTP
MTP
SPECIFICATIONS / ORDERING INFORMATION
京公网安备 11010802033920号
EEWORLD
