Features ....................................................................................................................................................................................... 1
Typical Phase Jitter (70 fs RMS) and Phase Noise Data ............................................................................................................. 2
Ordering Information .................................................................................................................................................................... 3
LVPECL and FlexSwing Termination .................................................................................................................................. 19
LVDS, Supply Voltage: 1.8 V
±5%,
2.5 V ±10%, 3.3 V ±10%, 2.25 V to 3.63 V, 1.71 V to 3.63 V ...................................... 20
HCSL, Supply Voltage: 1.8 V
±5%,
2.5 V ±10%, 3.3 V ±10%, 2.25 V to 3.63 V, 1.71 V to 3.63 V ...................................... 20
Low-power HCSL, Supply Voltage: 1.8 V
±5%,
2.5 V ±10%, 3.3 V ±10%, 2.25 V to 3.63 V, 1.71 V to 3.63 V .................... 20
Dimensions and Patterns ― 2.0 x 1.6 mm x mm ....................................................................................................................... 21
Dimensions and Patterns ― 2.5 x 2.0 mm x mm ....................................................................................................................... 22
Dimensions and Patterns ― 3.2 x 2.5 mm x mm ....................................................................................................................... 23
Revision History ......................................................................................................................................................................... 24
Rev 0.54
Page 4 of 25
www.sitime.com
SiT9501
Ultra-low Jitter Differential XO for Standard Networking Frequencies
Electrical Characteristics
ADVANCED
All Min and Max limits in the Electrical Characteristics tables are specified over operating temperature and rated operating
voltage with standard output termination shown in the termination diagrams. Typical values are at 25°C and nominal
supply voltage.
Table 3. Electrical Characteristics – Common to All Output Signaling Types
Parameter
Output Frequency Range
Symbol
f
Min.
Typ.
Max.
Unit
MHz
Condition
Refer to frequencies listed in
Error! Not a valid result for table.
s
ection.
Inclusive of initial tolerance, operating temperature, rated power
supply voltage, load variation of 15 pF
±
10%, and 10 years
aging at 25°C
Inclusive of initial tolerance, operating temperature, rated power
supply voltage, load variation of 15 pF
±
10%, and first year aging
at 25°C
Ambient temperature of 25°C
Extended commercial, ambient temperature
Industrial, ambient temperature
Ambient temperature
Extended industrial, ambient temperature
Voltage-supply order code “YY”
Voltage-supply order code “XX”
Voltage-supply order code “18”.
Contact SiTime
for 1.5 V
Voltage-supply order code “25”
Voltage-supply order code “33”
Pins 1 and 2 for OE and SE, respectively
Pins 1 and 2 for OE and SE, respectively
Pins 1 and 2 for OE and SE, respectively
See
Figure 6
and
Figure 8
Measured from the time Vdd reaches its rated minimum value
Measured from the time OE pin toggles to enable logic level to
the time clock pins reach 90% of swing. See
Figure 13
Measured from the time OE pin toggles to disable logic level to
the last clock edge. See
Figure 14
12 kHz to 20 MHz offset frequency integration bandwidth
We purchased several M430F5438A development boards and hope to develop FFT. However, when using the MSP-EXP430F5438 _User_Expertience (slac2271) provided by TI, the link error is as follows:
“
Linking...
Imagine being able to change your project MCU card according to your needs, almost like upgrading your computerhttps://www.hackster.io/MakerIoT2020/interchangeable-esp12-e-card-074268...
Why can't the internal resistance of a diode be ignored when the current is large? According to 1/rbe being approximately equal to Id/Ut, shouldn't the internal resistance be smaller when the current ...
I was browsing forums and news these days, and suddenly saw a new term - Wi-Fi 7
....Um....
No, wasn’t Wi-Fi 6 being promoted before? What the hell, I haven’t even used a Wi-Fi 6 router and I’m planni...
[i=s]This post was last edited by lugl4313820 on 2022-7-23 17:15[/i]After changing to the Ubuntu system, you can experience the xfce desktop.
1. After connecting to the development board with ssh, log...
Hello teachers, the circuit I sent before is different from what the teacher asked for. He wants the load to be at the bottom, and then the current flows from the power supply through the load directl...
The on-chip power supply circuit is a power module integrated inside the semiconductor chip. Its main function is to obtain electrical energy from an external power supply (such as 220V mains electric...[Details]
Although the sample rate cannot be set directly on any InfiniiVision oscilloscope, it can be set indirectly by adjusting the oscilloscope's time/division setting. This is because the Keysight MegaZoo...[Details]
The first blue book on the robotics industry, "China's Robotics Industry Development Report (2019)", edited by Harbin Institute of Technology Robotics (Shandong) Intelligent Equipment Research Instit...[Details]
Thermal gas mass flow meter is a commonly used flow measurement instrument, mainly for liquid, gas, steam and other media measurement, with the advantages of high measurement accuracy, good sensitivit...[Details]
Design a 4-story elevator MCU control system based on AT89C52 MCU. The system should meet the following functional requirements: 4-story elevator operation control, car and outside calls, operation s...[Details]
The CTC mode of timers 0 and 2 can generate a square wave with any frequency and a duty cycle of 50%. Fast PWM and phase correction PWM modes can generate square waves with arbitrary duty cycle. Howe...[Details]
The repetitive frequency high voltage pulse generation technology is a technology that has developed with modern scientific experiments. It mainly generates high voltage pulses with different param...[Details]
Google One is a consumer subscription service launched by search giant Google, which mainly provides cloud storage expansion (up to 100B) starting at as low as $1.99/month. Each Google account c...[Details]
introduction
Principle of frequency conversion energy-saving technology: Generally, the design of electrical traction equipment takes into account the possibility of short-term overload oper...[Details]
The Samsung Galaxy F62 is getting closer to its release date in India. The smartphone has been in production since early December, and a support page for the phone has recently been launched on...[Details]
Recently, Chengdu Shihai Xintu Microelectronics Co., Ltd. (hereinafter referred to as Shihai Xintu) completed tens of millions of yuan in Pre-A round of financing, jointly invested by Caixin Investme...[Details]
Introduction Weak Signal Detection is a subject that continues to develop with engineering applications. It uses electronics, information theory and physics methods to analyze the causes and rules ...[Details]
The reset function of the PIC16F87X series microcontrollers is relatively well designed. The conditions and reasons that cause the internal reset of the microcontroller can be roughly summarized into...[Details]
An outdoor photovoltaic module test platform proposed on the basis of the traditional working mode electronic load, with a programmable electronic load that automatically switches the working mode ...[Details]