This is a simulated clamp circuit experiment. When the "internal resistance" is not set for the signal source, the output voltage of PR1 follows the voltage of V2.After adding the internal resistance,...
[i=s]This post was last edited by Digital Leaf on 2022-11-1 20:49[/i]I have used boards that run microPython before, and I have also burned firmware into boards that support microPython firmware. Afte...
Article author: gaosi Article source: Mobile 3G website www.Goes3G.com/ Free WAP sites have gradually become a hot topic. In these sites, all resources including ringtones, games, dating, videos, and ...
Gpio module:
GPADIR determines whether it is input or output open-drain (open-drain) and push-pull (push-pull)GPAMUX selects the function pinGPADIR direction registerGPACTRLGPAQSEL
1. GPxMUX registerg...
Introduction Strain gauge sensors are widely used. They use a bridge circuit structure to improve output sensitivity. However, the output of a micro-strain bridge is only about 2 mV. Even under full l...