[i=s] This post was last edited by qwqwqw2088 on 2018-11-9 08:54 [/i] [b][size=4]Problem description: [/size][/b][size=4]1. [/size][font="]bq27441 Solution to FC not setting to 1 after being fully cha...
In order to minimize the crosstalk problem of single board design, after the PCB design is completed, it is generally necessary to perform a rule check on the line spacing 3W rule. The general process...
Let's do a fill-in-the-blank question before entering the post: Disassembling the machine is fun, ——————. (Fill in the second half of the sentence.)If you are working in the hardware industry, you may...
Is there any hardware expert who is good at camera, can you tell me the knowledge about camera circuit, such as what are the interface signal lines, etc....